It's a ratio of waste extracted at a mine and is expressed as:
(Total extracted - Mineral for plant) / Mineral for plant
-m0id.
efficiency is a product of the input versus the output
They are for stripping the insulation off electrical wire.
Stripping steam aids in separation in the column by "stripping' lighter components to higher trays in the column. While the crude is heated to a temperature where the pure components would normally go up, in crude oil the lighter components are often entrained in the heavier ones and the separation is not ideal. In actual practice stripping steam rates affect the flash points of the products as well as the concentration of hydrogen sulfide (H2S) in the products. The stripping steam added to the bottom of the column also affects the amount of overflash in the flash zone.
breakage or corrosion
The rate at which the cell increases in size depends on the DNA. The ratio of the surface area (calculated: length x width x # of sides) is divided by the cell volume (calculated: length x width x height). THE VOLUME OF THE CELL INCREASES MORE RAPIDLY THAN THE SURFACE AREA, CAUSING THE RATIO OF SURFACE AREA OVER VOLUME TO DECREASE. This decrease causes cell malfunction. If the cell volume increases too much, then the ratio will decrease causing problems for the cell's regular functions.
We divide the overburden thickness by ore thickness to get the stripping ratio For example if we have an overburden thickness of 80m and ore thickness of 50 m , then the stripping ratio will be: 80/50= 1.6
Yes, a 3:1 stripping ratio means that mining one cubic meter of ore will require mining three cubic meters of waste rock.
the stripping ratio fot the last increment alomg the pit wall. it determines whether one should continue mining using open pit(surface) or switch to uderground.
Overburden tons/ore tons
Cost Ratio = expenses/earnings
No. A ratio is calculated using division but they are not the same thing.
according to the calculated difference ratio with US dollar.
It means , the ratio has to be calculated. The ratio is = 52 :35.
How dose the cost income ratio is calculated in the banking model?
It can be calculated by simplifying the ratio between power of signal by power of noise
gross margin ratio is calculated as >GROSS PROFIT/NET SALES
Surface area and volume calculated separately. Then the ratio is taken