0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is pitch of a filet weld?
Pitch is center to center spacing of an intermittent weld.
Is plug weld's depth of filling to the right or left of the welding symbol?
When the depth of filling is less than the thickness (less than complete), it is specified inside the plug weld symbol!!!
What is a leading electrode angle for in welding?
what characteristics does the weld bead have when weaving the electrode
How much distance allowed between two weld toes?
2X the joint thickness. Maybe
What is the formula for a 45 degree lateral on 6 inch weld pipe?
formula for a 6" 45 degree lateral onto a 6" main
What is a tack weld?
When a welder makes a small weld bead to "tack" a joint together so it will not move. This makes it easier to weld a joint without having to clamp it.Tack welding is when a welder makes a small bead to "tack" the metal into place for the final welding.
What is the maximum load carrying capacity of a tack weld?
350kg
What is the first weld called when you are welding two beveled pieces of pipe?
tack
Butt-weld and grrove weld?
First, Butt-weld is short for a butt groove. Welding in a butt-groove starts at the throat of the butt-groove. The first weld point could be a tack-weld: holding the two materials to be welded together. The throat is measured and filler metal and electrode are determined to create the root pass.
How do you remove the door skin on a 2004 civic?
You have to break the tack weld on the lip of the skin that raps around the door fram.
Is the radiator support on a 1987 acura Integra bolted on or welded on?
The radiator support on all hondas/acuras are all tack welded in. you will see like a small indentation of a circle at every tack weld.
How do you remove the metal dashboard frame from a 1986 Chevy full size truck?
it is tack welded so u have to grind weld loose
How do you calculate weld deposit metal weight?
At first, the area of cross section of the weld, length of the weld, volume of the weld in cubic inches, weight of weld in cubic inches. To express in formula: Weight of Weld Metal = _ Êx ÊBase Êx ÊHeight Êx ÊLength Êx ÊWeight of Material.
Why is tack welding done before a complete weld joint is done?
Tack welding is short weld runs given when a work piece is assembled in strategic places. It help to combat pull in the metal associated with full welding runs. It also help in assembly and to rework material if mistakes in meterial measurements have been made as it is easy to break the tackweld of and start over
What mechanical properties of a weld in carbon manganese steel is most affected if the heat input per unit length of weld is excessively high?
Toughness
What is the required length for common weld bar joints?
Absorbs water and nutrients:))
How to weld motorcycle frame?
first as u begin to build your frame u want to make sure you have the best fitments as possible this bill help strengthen your motorcycle frame. ok let say you have every piece cut up to proper sizes as u begin to assemble this frame your going to tack it all together(this serve 2 purposes). to every tack you lay make sure you also tack in the opposite side( this is necessary to avoid any pulling/warping from the weld being layed down later )after the entire frame is completely tack check it for squareness in every possible direction specially your line of travel and your rear axle plates alignments , after u done all this and your satisfied with the frame go ahead and weld it . NOTE: AS U WELD YOUR FRAME MAKE SURE NOT TO PUT TO MUCH HEAT IN ONE SINGLE AREA AT A TIME JUMP ARUOND WITH YOIUR WELDS
