answersLogoWhite

0

Engine Coolant Temperature Sensor Circuit -replace the temp sender under the passenger side of the throttle body and reset the mil light.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

What is the 97 Subaru Legacy trouble code 66?

Trouble code P0066 Means: Air Assisted Injector Control Circuit or Circuit Low


What does the code p0743 indicates when trouble shooting a Subaru Impreza?

Trouble code P0743 means:Torque converter clutch circuit electrical


What does a p1507 code mean on your 99 Subaru?

P1507: Idle Control System Malfunction(Fail Safe). As per Subaru Trouble Code Info.


Check engine code 33 on a 1991 subaru legacy?

Code 33 means: Vehicle speed sensor (VSS) or circuit


What does code P2097 for a Subaru stand for?

Trouble code P2097 means: Post Catalyst Fuel Trim System Too Rich Bank 1


How do you diagnose cause of P0420 1999 subaru impreza?

Trouble code P0420 means:Catalyst system efficiency below threshold


How do you clear a Subaru 22 trouble code?

To clear a Subaru 22 trouble code, you can use an OBD-II scanner to read the code and then select the option to erase it. Alternatively, you can disconnect the vehicle's battery for about 15 minutes to reset the system. After reconnecting the battery, drive the vehicle for a short distance to ensure the code does not reappear. Always make sure to diagnose and fix the underlying issue before clearing the code to avoid future problems.


Where do you find the On Board Diagnostics for a 1990 Subaru Legacy Sedan?

You read the trouble codes on the dsahboard "engine check" light. To get the codes out you connect two black, single wire connectors under the dash near the steering column while the ignition is turned off, then turn the key on and the light should flash a code. More information can be found at... http://www.troublecodes.net/Subaru/ .


What is the po 753 code for a Subaru legacy?

The PO753 code for a Subaru Legacy indicates an issue with the "Transmission Fluid Temperature Sensor Circuit." This code typically suggests that there may be a problem with the sensor itself, its wiring, or the transmission control module. It's important to diagnose the exact cause to ensure proper transmission function and avoid potential damage. Checking the sensor connections and testing the sensor for faults are recommended steps for troubleshooting.


How do you fix 1999 Subaru Outback trouble code 1507?

the safety neutral circuit (on transmission not clutch) might be going bad. common with subarus


How to fix a DTC p0483 code on a 1998 Subaru Outback Wagon?

Trouble code P0483 means: Fan Performance Check all wires to van and fuses to make sure its working


Code 45 in Subaru?

The Code 45 you get in Subaru is as a result of the sensor which will cause the fuel cut.