12 volts is less of power than 18 volts drill
They can look the same, so I would take the number from it and have it looked up at a parts store using there BUYERS GUIDE.
The capacities of batteries are rated in amp hours. The higher the amp hour rating of a battery the longer the device connected to the battery will operate. Depending on what the connected load draw in amps is, will determine how long the connected device will operate.
If your cart has 4, 12 volt batteries in series to make up the 48 volts, just connect the 12 volt lights across one of the batteries.
Yes. Many 12 volt bulbs get very dangerously hot, for instance the 12 volt bulbs that are commonly used in vehicle headlights and in small 12 volt 50 watt overhead ceiling lights in homes.
If it is a 12 volt panel it will light a 12 volt bulb. Most likely it is not a 12 volt panel, it is some other voltage, so you then need equipment like an inverter to convert the energy to 12-volt energy.
The 12 volt battery has double the electromotive force of the 6 volt. Electromotive force is measured in volts.
* dsawdasdadwwwwwwgfw
One is 9 volts and the other is 12 volts. They do not interchange!
lets think ones more powerful than the other......12<18....only my opinion
you can just check it properly... (on every battery volt is surely given...)
They can look the same, so I would take the number from it and have it looked up at a parts store using there BUYERS GUIDE.
connect + to + and - to - and connect the load between the two + and the two -
Running a 9 volt Motor on a 12 volt BatteryUsually, I have gotten away with this, BUT... depending on the quality of the windings in the motor, it could burn through the tiny wire in the motor winding. I have done this many times with no problem, but have also burned out a few motors.One good example is that I have several [from the "early" days] cordless drills. The early ones used anywhere from 6 to 9 volt battery packs.I then bought a 12 volt drill at Harbor Freight and Tools, and when I got it home and examined it I realized that the 12 volt battery pack was IDENTICAL in size to the older 6 and 9 volt packs.So, after charging the new 12 volt pack, I tried it in the older 6 and 9 volt drills. Lo and behold, it worked fine, with just a little more RPM and drilling power.I then called my Electrical Engineer brother and asked him about it and he said that those small drill motors are not that sensitive to even a doubling of voltage and perform OK with 12 volts on 6 and 9 volt units.That was about 4 or 5 years ago, and for some time, I've been using 12 volt battery packs for all three units [6, 9, and 12 volts]. When time came to replace failed 6 and 9 volt units, I switched to 12 volt packs for all 3 drills.Again, I think 12 volts will be safe for your 9 volt motor, but it depends on the motor.
The difference is 12.
12 volt
12 volt
No. You need 12 volt AC to run a 12 volt AC motor, not 12 volt DC.