Small lines like 5/16 or 13/32 hoses are high side/pressure and liquid lines..........
Large lines like 1/2 or 3/4 hoses are low side/pressure lines.........
AC amplifiers are used to amplify AC signals and use components that handle large voltage values. DC amplifiers are used to amplify DC signals which use small powered electronic devices.
small signal basically it's about linear operation around the quiesient point. large signal is actually talking about "total signal". so just take both dc and ac into account.
under car folow ac lines into small tube protruding out near them
The diac and the triac are used to control the AC lines. The difference is that triac are bigger than diac.
You always want to put freon in an ac by using the small fitting low side on 134a systems. The large fitting is high side. Do not use it
The low pressure port is the one on the accumulator (the canister). The low pressure lines are the bigger lines and the high pressure are the small lines.
letters of the alphabet
There is no difference between AC AND DC chockes
Pressure gauges. In a home or car AC there is small pipe and a large pipe going to the compressor unit outside or in the engine compartment. The large pipe should be cold and "sweating" ( dripping water).
The difference AC and DC grounding is that AC is alternate current and DC is direct current. Grounding for both AC and DC is the same.
There is no difference in the cables. The only difference is the type of electrical power being transmitted. AC or DC applications use the same wires.
It is a large silver cylindrical shaped valve with both A/C lines going to it. Trace your A/C hoses to locate it.