whats the voltage??? at480 volts the Fla would be 33.75 or 35 amps. at 230 volts it would be 70 amps. i would go with the 480 myself because its less amps.
<<>>
The voltage stated in the question is 600 volts. There are 746 watts in 1 HP so in 20 HP there would be 746 x 20 = 14920 watts. I = W/E. 14920/ 600 = 24.8 amps. The proper formula to use would be I = HP x 746/1.73 x E x %Eff x pf. Without knowing the efficiency and power factor of the motor an accurate answer can not be given. In the trade, a quick rule of thumb is, for 600 volt motor installations, it is 1 amp per horsepower which is close enough to calculate the feeder wire size.
current, Amps= 4 (746)/240(0.8)
=746/60*08
=746/48
= 15.5 amperes.
<<>>
This is the formula that you are looking for. I = HP x 746/E x %eff x pf.
A standard motor's efficiency between 5 to 100 HP is .84 to .91.
A standard motor's power factor between 10 to 100 HP is .86 to .92.
It depends on the motor's efficiency, and power factor. At least 24A (100% efficient, 1.0 pf).
I searched for a few 7.5hp, 240v singe phase motors and found 30 - 45A.
On 240 v the current can be estimated as 7 amps per horse power, so that is 35 amps for 5 HP.
1 hp = 746 watts
total power = 746 * 7.5 =5595 W
voltage = 240 V
P=V*I
5595=240 *I
I=23.3125 A
Depends on how big the motor is. A stronger motor will draw more amps then a weaker or less efficient motor. For example a wiper motor draws far less then a starter motor.
read the name plate on the motor
A single phase 10 HP motor will draw aproximately 50 amps. A three phase 10 HP motor will draw aproximately 28 amps.
Then you are trying to get more HP out of the motor that it can supply. Back off on the load that the motor is driving or put a bigger motor onto the load.
110 volts divided by 1,300 watts(1.3 kw) = .09 kw or 900 watts.
Depends on how big the motor is. A stronger motor will draw more amps then a weaker or less efficient motor. For example a wiper motor draws far less then a starter motor.
read the name plate on the motor
A single phase 10 HP motor will draw aproximately 50 amps. A three phase 10 HP motor will draw aproximately 28 amps.
8,33 Amps
24.87amps 1 hp=746 watts P=IxV ... (746x8)/240
it draws 210 amps
It is drawing .06 amps.
Then you are trying to get more HP out of the motor that it can supply. Back off on the load that the motor is driving or put a bigger motor onto the load.
110 volts divided by 1,300 watts(1.3 kw) = .09 kw or 900 watts.
It would be at least 250 amps, maybe 300 amps.
1.25 amps
That depends entirely upon the type of motor. A car starting motor may take a few hundred Amps for the short period.