0
What else can I help you with?
How do you replace a 2002 Isuzu trooper starter?
To replace it remove the battery terminal so you will not have power. Loosen the bolts (use liquid wrench or wd40 for this will be rusty) exhaust pipe from the exhaust manifold (driver side) and then you need to loosen the exhaust pipe from the exhaust manifold to the part where it connect exhaust pipe from the other side of the exhaust manifold (passenger side) and then you need to loosen the electrical wire from the starter and then loosen the bolts that connect the starter now you can wiggle the starter to pull it out you need to try to figure out how to get it through the loosen exhaust pipe ( but it should come out)
Some cars have their exhaust pipe on the right side while others have it on the left but cars never have the exhaust pipe in the centre Why is this?
because your gas tank is in the center
How do you remove a starter on a 1994 Isuzu trooper?
You have to remove the exhaust pipe from exhaust manifold on starter side. Now you have access. Get exhaust pipe to exhaust manifold gasket first, you will probably need to replace it after taking them apart.
Where is the O2 bank one sensor two located on a 2000 Chevy silverado 5.3 liter v8?
Back 1 Is the drivers side head and exhaust pipe . Follow the drivers side exhaust pipe back towards the muffler and you will see the O2 Sensors screewed into the exhaust pipe. I believe there's 2 per pipe.
Where is the o2 sensor on a 92 jeep wrangler?
Drivers side of the engine in the exhaust pipe below the exhaust manifold.
What determines gas cap location when a car is designed?
The opposite side of the exhaust pipe. If its dual exhaust, whatever side works best for manufacturing.
Where is oxygen sensors on 2004 f250 5.4 engine?
before the cat converter on the exhaust pipe on the passenger side of the motor, down beside the gearbox. has a large nut on the side of the exhaust pipe and a wiring harness and plug coming out of it.
Where is the oxygen sensor on a 94 ford aerostar?
on the exhaust y-pipe on the passenger side
What is a dual exhaust system?
it has 2 mufflers. the exhaust pipe splits into two pipes and the you got a muffler on each side of the car...
What is a exhaust pipe used for?
An exhaust pipe is used to excrete the co2 from the gas that has been burned in the engine it is usually snakes to thw back or side of the truck so that it is out of the way. If you get a bigger exhaust pipe than the stock one you can usually get some more power from your engine. You can also get an exhaust kit with a switch the can change the amount of exhaust exiting the pipes.
Where is oxygen sensor bank 1 sensor 2 located on a 2005 Chevrolet truck?
Bank 1 is the drivers side head. The sensor you want will be screewed into the drivers side exhaust pipe and will be the 2ed one back towards the muffler in the drivers side exhaust pipe.
Where is the O2 bank two sensor one located on a 2003 Chevy Silverado?
That will be the passenger side head. Look at where the exhaust pipe bolts to the exhaust manifold and it will be the first 02 sensor you see starting there and moving down the exhaust pipe.
