Want this question answered?
Actuate the bolt to the rear and there is a tang in front of the trigger that hangs down..Press up on this tang and pull the bolt back and it will remove it from the action.
If you mean the magazine, there is a magazine release button on the left side of the gun. You press the button and the magazine comes out.
To remove: Open action, press trigger rearward and pull bolt entirely from receiver. To install: Insert bolt in receiver, push bolt over plunger in bottom of receiver, pull trigger and complete forward travel of bolt; then rotate bolt handle downward to lock.
Remove the magazine cap and forearm, then remove the barrel and mag tube. At the end of the tube will be a metal cap that you can carefully pry out with a screwdriver, some press in and turn to remove them. Use caution, it is under spring pressure.
I press the "Program" key. Type the number in I wish to store. Press the memory location button I wish to use. Press the Program key again. Lift the hand set for laughs. Then press the memory location to ensure the number is stored.
For Verizon users call blocking can be deactivated by :Press *82 + the number + SEND.
Press start then press remove programs simple!
use a slide hammer to remove the hub from the bearing. do this on the car. or remove complete knuckle and press hub out with a press
Press the red button 3 times, then squeeze activation bars once. Some units require a different number of presses - 1, 2, 3, or 4.
Press the manuel button then press the channel number you want to program and then press the manuel button again. Press the frequency numbers in t\and then press the "E" for enter. Now your police scanner is programmed. :)
Remove the wheel, Remove the hub, take hub to a press, then press it out, installation is opposite removal.
press remove video