0
100amps
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What is the rating of the main circuit breaker of the 60kw power distribution panel?
200 amps
Can a 150 amp panel be upgraded to 200 amp?
"CAN"? Certainly. But you will need to run a new service cable. You'll need to have your licensed electrical contractor work out the details with your local electrical power company, and get the appropriate permits.
What is a 200 amp four lug panel?
An electrical panel for 3 phase power with three hot connections and a neutral bar. It's capacity would be 200 amps on each of the three legs.
Can you run a 200 watt bulb with a 160 watt solar panel?
only if u use a battery to boost power ,
How much power do solar panels provide?
A common solar panel can produce around 200 watts of power and can vary based on the size and efficiency of the solar power you chose. There are also three things that can affect the amount of electricity that a solar panel produces: the amount of sunlight, the size of the panel and the efficiency of the solar cells.
What size wire for a 200 amp 3phase service 100 feet away?
This is a voltage drop question. A voltage must be stated to answer this question.
How much does a 200 watt solar panel cost?
About 200 Dollars
How do you calculate size of electrical panel?
The sizing of an electrical panel is based on the total connected load. Most new homes today will use a minimum of 200 amp panel. This size distribution panel will give ample room for expansion in the future. As more and more appliances and larger connected loads appear on the market, distribution panels have gone from 30 to 60 to 100 to 125 and now the standard is 200 amps.
Can a 200 amp breaker be purchased that only occupies 2 slots in the panel - if so where?
No. You can not buy a 200 amp that only occupies 2 slots on the panel.
What is 200 to the fourth power?
The answer to 200 to the fourth power is 1,600,000,000
Which alternative energy sources create electricity but not by turning a turbine?
A solar panel produces electrical energy with no moving parts. With the Sun facing the panel, 150-200 watts per square metre can be produced by a solar panel. Without direct sunlight a panel still produces power, but very little (e.g. 5-10 watts from a bright sky).
What would happen if a 200 amp breaker is used in a 100 amp sub panel?
There are two things to think about here. First of all a 200 amp breaker will not physically fit into a 100 amp panel. This is so designed because the panel buss is not designed to conduct 200 amps before the current is cut off. A 100 amp rating on the panel is the maximum amount of current that the manufacturer states, that can be handled safely. Second if the 200 amp breaker is in the main panel then everything downstream from that breaker has to be rated for 200 amp conductivity. The wire size will have to be 3/0 from the breaker to the first over current device in the sub panel which will be the sub panel's main breaker. The sub panel can not be a load center but will have to be a combination panel. I doubt that the 100 amp sub panel's main breaker lugs would be large enough to connect the 3/0 cable.
