answersLogoWhite

0

I am just guessing but a slinky bracelet

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Why does the RPM go to 0 when it on?

it sounds like a wire is not connected or is shorted.


What is a ball ended?

it is a magnet having two poles in their ends. they have a wire like structure in the middle.


How do you test to see what speaker wire is positive and negative?

To determine which speaker wire is positive and which is negative, you can use a simple method involving a battery. Connect the two wires to a small battery (like a 9V battery) briefly; if the speaker cone moves outward, the wire connected to the positive terminal of the battery is the positive wire. If it moves inward, the wire connected to the negative terminal is the positive wire. Be cautious not to leave the wires connected for too long to avoid damaging the speaker.


Radio doesn't work unless headlight switch is turned on?

The radio was wired wrong. Sounds like the hot wire for the radio was connected to the hot wire for the headlight switch.


What does a stater look like for a 1995 jeep grand Cherokee?

Should be on bottom of motor connected by 4 bolts silver round like oil filter longer next to it is probably the starter relay 4 wire terminals connected also connected to starter.


Your speedometer doesnt work all the time like if it wasnt connected?

Your speedometer might not be connected if it does not work. It might also have blown a fuse if it is an electronic speedometer or it could have a wire that is loose.


Why wont my Ford galaxy boot door lock?

Its your wires they are not connected properly you have what it is called a short or a not connected wire this will cause other problems like flickering lights and other electrical problems


How do you install multiple GFCI receptacles?

A GFCI receptacle can extend its protection to regular receptacles connected to the output side of the GFCI. Each actual GFCI receptacle should be directly connected to a breaker in electric panel.


How does communication work?

Not sure what you mean by "wire communication". Are we talking like the phone lines, or the physical wires your computer is connected to, or did you mean wireless?


When you connect earth wire in ceiling light does not work when connecting earth from light direct to earth wire coming from ceiling trips out when take earth wire out light works?

By earth wire I am assuming you mean the bare wire and that a black and white wire are connected to the light. If when you connect the earth wire and breaker trips then there is a short between black and earth. It could be a bad ground connection, an internal short in the light fixture where black wire "hot" is connected to metal on the fixture through a nick in wire.


How could we make the electromagnet with rivet and some wire?

To make an electromagnet using a rivet and some wire, first wrap insulated copper wire tightly around the rivet, leaving enough wire on both ends for connections. Ensure the coils are neatly stacked and avoid overlapping to maximize magnetic strength. Once wrapped, connect the ends of the wire to a power source, like a battery, making sure to observe proper polarity. When powered, the rivet will become magnetized, creating an electromagnet.


Can grounds and neutral wire share same buss bar?

No, the ground and neutral wires should not share the same bus bar in an electrical panel. The ground wire is for safety and should be connected to the ground bus bar, while the neutral wire is for returning current and should be connected to the neutral bus bar. Mixing them can cause dangerous conditions like electrical shock or fires.