The administrative distance of a default route is 1 (one) and is seen as a static route.
The administrative distance of a default route is typically 1. This means that it is considered the most reliable and preferred route for forwarding traffic when no other more specific route is available in the routing table.
The "show ip route" command in Cisco devices will display the administrative distance of routes along with other routing information.
According the AA Route Planner (GB Edition) the distance is 92.7 miles, this will take about 2 hours and 7 minutes to drive, assuming you take the direct route and there are no stops, accidents, breakdowns or other hold ups en route.
According the AA Route Planner (GB Edition) the distance is 80.8 miles, this will take about 1 hours and 42 minutes to drive, assuming you take the direct route to the centre of each location and there are no stops, accidents, breakdowns or other hold ups en route.
The distance between Newcastle upon Tyne, Tyne and Wear, and Portsmouth is approximately 280 miles (450 kilometers) by road. This distance can vary depending on the specific route taken and mode of transportation used.
The driving distance from Fresno to Oakland is approximately 167 miles. The most common route takes you north on Interstate 5 and then west on Interstate 580.
by default the administrative distance is one (1), but you can give it an optional value. The metric is zero (0).
120
The "show ip route" command in Cisco devices will display the administrative distance of routes along with other routing information.
Compared to RIP, EIGRP has a lower administrative distance.
Administrative distance refers to the trustworthiness of a particular route. Routes with the smallest metric to a destination indicate the best path.
Administrative distance refers to the trustworthiness of a particular route. Routes with the smallest metric to a destination indicate the best path.
generally static routing protocol has the most trustworthy administrative distance .i.e; 1 and in dynamic routing protocols EIGRP has the best AD.
The route via Path B is installed because the EIGRP route has the best metric to network 10.2.0.0/16. The route via Path A is installed because the static route has the best metric to network 10.2.0.0/16. The route via Path B is installed because the EIGRP route has the lowest administrative distance to network 10.2.0.0/16. The route via Path A is installed because the static route has the lowest administrative distance to network 10.2.0.0/16.
120
Default route
When you have routing enabled then you need default route (also calleddefault network or Gateway of Last Resort). You do not need default routeif you don't use routing. For example if you just have one router in your network there is no need for default route. When you have more than one router in a network you need default route.Note: If you connect to WAN (Internet) you need default route. The default route allows connection with Internet. If you are not using WAN and have one router than there is not need for default route but in these days everyone connects to the Internet so most likely your router has default route. When using router to connect to the Internet using DHCP this happens automatically so there will no need to configure default route manually. If you need to manually set default route then use the commands IP default-network or IP route 0.0.0.0 0.0.0.0 .More info can be found at Cisco's site - see the related link below.
ip default gateway