It does not require the continuous checking of I/O port by the computer . The computer checks the port only when an I/O interrupt is encountered . It saves processing time.
1.Programmed IO is the process of IO instruction written in computer program , where Interrupt Initiated IO is done by using interrupt and some special command. 2.The advantage of Interrupt Initiated IO is ,it is a time consuming process than Programmed IO. 3.In Programmed IO technique to transfer data,required constant motoring on peripheral by CPU,once data transfer is initiated, CPU have to wait for next transfer. In Interrupt Initiated IO once data transfer initiated ,CPU execute next program without wasting time and the interface keep monitoring the device. When the interface determines that the device is ready to transfer data, it generate an interrupt request,CPU stop the current task,execute the transferring process,and then return to the previous on-processing task.
The type of data transfer that is carried out using a USB port are varied. Some of the types of data transfer include bulk data transfer, isochronous data transfer and interrupt data transfer among others.
The interrupt process is simple. The 8259 is combined with many interrupts inputs.
Here is an example sentence using the word interrupt. Bill will always interrupt Sally when she is telling a story about him.
DMA (Direct Memory Access) does not actually interrupt the CPU - it requests control of the bus, so that it can perform the transfer itself. It becomes a bus-master. This is done using the HOLD and HLDA (Hold Acknowledge) control pins. This is not the same thing as an interrupt, which is where an external device requests the CPU's attention, and the CPU goes off and performs some code to service that request. In the case of DMA, the CPU actually freezes for the few cycles that the DMA controller requires, which is much, much more efficient than using an interrupt service routine.
The interrupt request lines on the 8085 (INTR, RST7.5, RST6.5, and RST5.5) can be disabled using the DI (Disable Interrupt) instruction. You re-enable with the EI instruction. Also, RST7.5, RST6.5, and RST5.5 can be individually enabled and disabled using the SIM (Set Interrupt Mask) and RIM (Read Interrupt Mask) instructions. The TRAP interrupt request line cannot be disabled.
In the 8086/8088, the interrupt vector table is the first 1024 bytes of memory. In the 8085, the interrupt vector table is the first 64 bytes of memory if using the RST form of interrupt, otherwise the interrupt vector is provided by the interrupting device, usually in the form of a CALL instruction. The interrupt handler is wherever the interrupt vector points to.
Sorry to interrupt, but the files are ready to be photocopied. I wish you would not interrupt me while I am deep in meditation. How dare you interrupt my sentence again, you imbecile! This is the last time you will interrupt our dinner, Jenny, before I come over there and smash that phone through your face. If you interrupt the teacher while she is speaking, you will get a warning. Don't interrupt me today, I have far too much work to be getting on with.
What is the advantage of using an PLM
advantage of using template in an orgainsation
Here are two examples:Do not interrupt me when I'm speaking.When did you last see him?
the advantage of using tjis type of propagation is how the plant reproduce