Want this question answered?
The sizing of the circuit breaker and hence the wire size to feed the pump are all dependant upon the amperage of the pump. This question can not be answered without that information.
Depends entirely on the voltage and current rating of your pump.
A breaker is based on the amperage that is drawn by the pump motor load. Find the full load amperage of the motor. The wire fed from the breaker has to be rated at 125% of the motors full load amperage. The breaker for motors have to be over sized, usually 250% of the motors full load amps.
No, they each need their own breaker of the right amp. Neither of them would cause the breaker to trip if there was a problem.
For an accurate calculation it will be necessary to know what the size of breaker exists in the pump house and what size conductors are used. Power loss is measured using actual amps required, not size of the circuit involved. But the size of circuit (breaker size) can be used. Voltage must also be known.
How to winterize a Gould's deep well pump
I have a deep well MW jet pump installed in 1978. The pump has only MW designation, but the motor has the Goulds name on it, so I suspect they were produced by Goulds.
waht is the value of a goulds hand water pump, cast iron red, sc 9119 made in seneca falls n.y.
Ile2211ca314ea3
Goulds Pumps is an American manufacturer of various industrial pump systems. They make pumps for several industries, including but not limited to mining, petrol-chemical, oil, water and waste processing.
banana apple plum
No one bought ITT Goulds in Ashland. It lost 86 employees early this year and transferred its slurry and pump assembly, testing and order entry processes from Ashland to its Seneca Falls operation. Ashland operations is the former Goyne Pumps works (established 1908) that was purchased by Goulds Pumps, Inc. in 1979 before it became part of ITT Industrries in 1997.
The sump pump breaker alarm will keep going off if it is being overloading. This is usually a result of a failing pump or a clogged filter.
i came across a new site called gouldswellpumps.org and maybe you will find the answer on there as it is all about goulds well pumps and submersible well pumps
Normally AWG #10 wire on a 30 amp breaker but it really depends on the size of the pump. The pump manufacture will specify the size wire and size breaker needed.
The sizing of the circuit breaker and hence the wire size to feed the pump are all dependant upon the amperage of the pump. This question can not be answered without that information.
No.