0.20 - 0.75 g/ml as given in the Handbook of Public Water Systems.
Tapped density is the term used to describe the bulk density of a powder (or granular solid) after consolidation/compression prescribed in terms of "tapping" the container of powder a measured number of times, usually from a predetermined height. The method of "tapping" is best described as "lifting and dropping". Tapping in this context is not to be confused with tamping, sideways hitting or vibration.
Bulk density is defined as the weight per unit volume of material. Bulk density is primarily used for powders or pellets. The test can provide a gross measure of particle size and dispersion which can affect material flow consistency and reflect packaging quantity. Bulk Density ASTM D 1895 B
400 Kg/m3
A value for porosity can alternatively be calculated from the bulk density ρbulk and particle density ρparticle: Normal particle density is assumed to be approximately 2.65 g/cm3, although a better estimation can be obtained by examining the lithology of the particles.
The speed of sound varies with various factors such as temperature,nature of the material,physical state of the substance,etc.
Bulk density = dry weight / volume, then by knowing the dry weight and bulk density we can calculate the volume.
bulk density depend on that material from which soil formed. so maximum bulk density depend on particle density of that mineral. Therefore,we can only tapped the soil upto perticle density. so maximum bulk density may be occur at equal to paricle density.
Definitely, soil texture influences soil bulk density
Tapped density is the term used to describe the bulk density of a powder (or granular solid) after consolidation/compression prescribed in terms of "tapping" the container of powder a measured number of times, usually from a predetermined height. The method of "tapping" is best described as "lifting and dropping". Tapping in this context is not to be confused with tamping, sideways hitting or vibration.
Bulk density is the dry mass of the solids (M sub t) / total volume (V sub t) Particle density is bulk density (P sub b) / 1 minus total porosity (1-theta).
I believe that it may be the same (or similar) to bulk density
Bulk density of coking coal depends on many factors. But commonly it can be told as 0.8 T/Cu.M.
hdgyuexuvuvexcuwve
The bulk density of short chain, single walled carbon nanotubes are roughly 1.3-1.4g/cm3 (1300-1400kg/m). The bulk density is the density of a bundle, or group, of nanotubes together. The bulk density changes depending on the length of tubes, diameter, how many walls there are, and how they are ordered and packed, and can be as low as 0.15g/cm3. The true density, or, the density of just one tube, is closer to 2.1g/cm3. This changes very little with length, diameter, or number of walls. http://www.cheaptubesinc.com/ShortCNTs.htm Refrence: http://arxiv.org/ftp/cond-mat/papers/0601/0601370.pdf
for beans
Bulk density is defined as the weight per unit volume of material. Bulk density is primarily used for powders or pellets. The test can provide a gross measure of particle size and dispersion which can affect material flow consistency and reflect packaging quantity. Bulk Density ASTM D 1895 B
You're almost certainly asking about bulk density. I hear it mispronounced as "bunk" density daily. Bulk density is how much mass of a substance will fit into a given volume without any packing. It tells you about the particle density and also the packing order.