The cause of resistance is the opposition to the flow of charges.Resistance occurs due to the collisions between charges inside a substance.
The resistivity of a wire can be found out by using a meter bridge or a slide wire bridge.
Resistance in any conductor is inherent in nature. Some conductor has less some have more comparatively. The resistance is measured in Ohms using a standard multimetr
If you are asking if a hot wire has a greater resistance than a cold wire then the answer I would say is yes. Cold wires have always had less resistance than hot wires
Your current will be 30/R Amps. Where R is the resistance in Ohms.
Ni chrome is a low resistance wire used in heaters and toasters.
If the wire length is 100m and the Diameter is 1mm calculate the Resistance of wire?
Yes, the resistance is directly proportional to length of wire and inversely proportional Area, hence when Length of wire increases the resistance also increases and when Area increases the resistance decreases. This means a thick wire has least amount of Electrical resistance.
Short wire has less resistance Long wire has more resistance Thick wire has less resistance Thin wire has more resistance
Electrical resistance can be determined by the equation that defines resistance - Ohm's Law. Just divide the voltage across a resistor, by the current passing through it.
Resistance, which is measured in ohms. long wires and heat are the main cause of resistance increases.
it has to do with ohms and the gauge of the wire. if you have a low ohms then you can't use a small thin wire. because the more ohms the more resistance. if you have a low omhs on a thin wire it can cause the wire to heat up. posibly catch fire.
increase of temp cause increase of specfic resistance...... bcz atoms exictes and cause hindrance in motio of free electons so by increasing temp specfic resistance increasaes
it will cause a Short Circuit
A thicker wire has less resistance than a thinner wire.
A thicker wire has less resistance than a thinner wire.
Other things being equal, more cross-sectional area will cause less resistance.
resistance of wire increases with increases of length
When a wire is made thicker it's resistance decreases.
In general, the longer the wire the greater the resistance. The only time that this is not so is when the wire is a superconductor, in which case the resistance is always zero.