0
Need more information, but here are some examples for pipe elbows; you need to enter the elbows' centerline radius:
10" steel pipe with a 2R or 10" radius:
if it is a 90 degree ell C/L-to-END is 10"; for a 76 degree ell it is 7.81"
10" steel pipe with a 3R or 15" radius:
if it is a 90 degree ell C/L-to-ENC is 15"; for a 76 degree ell it is 11.72"
The way to calculate this is to draw a right triangle with the smaller angle being 38 degrees (half of the 76 degree angle). The length of the triangle's "side adjacent" to the angle will be the length of the ell's centerline radius (15" in the case of the above 3R elbow). Multiply the tangent of the angle of 38 degrees by the length of the ell's centerline radius to get the length of the ell's "centerpoint-to-end" length.
What else can I help you with?
How do you clean stainless steel cooking pots?
Soap, water & elbow grease.
How do you calculate 45 degree steel elbow weight-- need a formula?
The easiest way is to find the centerline length and multiply that by the linear weight of the pipe size being used. Alternatively, this formula should give the weight of an elbow in pounds: w=0.071*pi^2*R*(ro^2-ri^2) Where: w= weight of elbow (lb) R=curve radius of elbow (in) ro=outside radius of pipe (in) ri=inside radius of pipe (in)
How can you fix leak in elbow carbon steel 8 inch?
If the leak is in Elbow better change it. For a short time you can use welding to seal. It depends on the medium, temperature and pressure critically
How center of mass can not lie with in the body?
The simplest answer is to look at it this way. Take a circular piece of steel (not a flat disk but a rod formed into a circle). The center of mass will be in the center of the circle, which is not within the body of the steel.
Is the core of an electromagnet a piece of steel in the center of the coil?
no
What state became the center of steel production?
Pennsylvania
What do you mean by killed steel?
Killed steel means Deoxidized steel - it is a steel with some degree of oxygen removed from the melt. Four types of killed steel are: killed, semi-killed, capped, and rimmed.
How do you remove rust from tools?
Navel Jelly, available at any hardware store, or good old steel wool and elbow grease.
Which is colder steel or wood at zero degree centigrade?
If you mean the air around them is 0 degrees, then the steel would be colder.
Why do you think Pittsburgh became a center of steel industry?
Because they have steel statues in their town square and they make the most steel in the USA.
Which city is the center for Mexico's steel industry?
No. Mexican steel industry is centered around the city of Monterrey, in northern Mexico.
How was the bmx bicycle originally made?
Pretty much the same way most bikes are built. Thin-walled steel pipes are cut to length and mitered, and the joined together by welding or brazing. Rims are made by either steel strips or alloy extrusions rolled into hoops and joined together, then laced to hubs. Cranks are usually forged.
