Class A amplifiers for signals and class AB for power output. The bias is often set up as a self biased amp.
Ce configuration is preferred because the current amplification factor beta ranges from 20 to 800 . Thus, the current gain n voltage gain at output will have appreciably high value .
That depends on both the input signal and the type of amplifier the transistor is used in.
A high signal input to a transistor amplifier gives a high signal output provided it stays linear.
3Db
A simple, 1 transistor single stage amplifier can be made using several resistors to bias a NPN or PNP transistor into its' linear operating region. With this done, a small voltage signal applied to the input of the amplifier will have the voltage amplified at the output in a linear fashion. I'm not sure what your question is; if this does not answer it let me know.
The signal gain of a CE BJT amplifier is hFe or collector resistance divided by emitter resistance, whichever is less.
That depends on both the input signal and the type of amplifier the transistor is used in.
A high signal input to a transistor amplifier gives a high signal output provided it stays linear.
amplifier consists of active components like transistor fet etc,. for example transistor, it produces high output is common emitter configuration. when u give weak signal to the base of the transistor and the output is taken in collector terminal(amplitude of the weak is increased, so the output is high ) its known as amplifier
A circuit in which the input signal is applied to its base and the collector is earthed (grounded) is known as common collector configuration of BJT (BiPolar Junction Transistor)
A transistor is an electronic component. By itself it has little use. An amplifier is a complete, functional circuit, generally made up of several components. A transistor can be a component part of an amplifier, however an amplifier may be constructed without any transistors (using vacuum tubes instead, for instance).
This is a particular transistor amplifier configuration. In general, the input signal is applied to the base, the collector is connected to a supply voltage, and the output is taken between the emitter and power supply common. One of the characteristics of the emitter follower is the output voltage "follows" the input, but the output is reduced by the Vbe voltage (the voltage drop between base and emitter, approximately 0.7 V for a silicon bipolar transistor).
The name is your clue: a transistor and a resistor (the load) are put in series. The output signal is taken from the load resistor. A small input signal (to the third lead of the transistor) will cause the transistor to change resistance ... thus you can get a large output from a small input Amplification.
3Db
the electrical signal coming out from the micro phone is very low &this cannot drives the loud speaker.For this purpose we incresing the signal level which is coming out from the microphone (usually an Ac signal)is known as amplifier.it cannot incresing this signal level without using external energy(as per law of conservation of energy rule)For this we use external dc energy.only the device which can convert the external dc energy into ac energy is transistor. so we say transistor as an amplifier
A: Feedback is a signal fed back from the output like from collector to the base .
A simple, 1 transistor single stage amplifier can be made using several resistors to bias a NPN or PNP transistor into its' linear operating region. With this done, a small voltage signal applied to the input of the amplifier will have the voltage amplified at the output in a linear fashion. I'm not sure what your question is; if this does not answer it let me know.
An unbiased transistor is one being used with no bias voltage to offset its operating point. If the input signal is very small it still can operate as an amplifier but the output will be non-linear. One use for an unbiased transistor is when the transistor is used as a switch, turning it on or off.