A light bulb and a battery simply being is not an experiment, so there is no variable at all.
Draw a battery and light bulb. Draw a line from the smaller connector on the battery to the bottom of the light bulb, this is positive on both. Draw a line from the bigger connector on the battery to the side of the light bulb,'this is the negative of both. Looked all over and can't seem to find this one.
I am going to assume you meant Three wires, Battery and Light Bulb. (punctuation and plurals are important) Hook the light to one post of the battery Hooked from the light to the item being tested (use the other light connection, not the one connected to the battery) connect the other end of the test item to the unused terminal on the battery. Light comes on means it conducts electricity No Light, it does not.
To answer this question the amp hour rating of the battery is needed along with the voltage of the battery or bulb.
Yes, for about .1 second, then it will blow the lamp. A 9v battery will however light three 3.5v lamps.
Light bulb in the home - alternating current (A/C) Light bulb in a car - direct current (D/C) Output of a battery charger - direct current Input of a battery charger - usually alternating current
what is a conclusion for a battery powered light bulb
You need a Battery, Light Bulb, Ammeter, Switch.
Draw a battery and light bulb. Draw a line from the smaller connector on the battery to the bottom of the light bulb, this is positive on both. Draw a line from the bigger connector on the battery to the side of the light bulb,'this is the negative of both. Looked all over and can't seem to find this one.
i would say no because the battery has a lot of energy to pass to the light bulb and not a pataoe
yes
The light bulb can be controlled on a timer, or simply manually switched on and off. The heat can be controlled by using a thermostat. Some bulbs also provide both light and heat, and by raising the bulb the heat can be approximately controlled.
The battery chemically stores electricity so when you 'switch on' the light then electricity flows from the battery to the bulb. The bulb the heats up to glow white and the reflector shines the light out of the battery powered light
Make a circuit with 2 wires a batery and a light bulb and touch wire to medle on light bulb
Get your bulb, it should be a very small wattage (weak) one, get your battery and wires, connect one wire to plus side of abttery and other wire to minus side of battery, then connect to the bulb, you may have to play around a bit to find a connection that produces light.
It doesn't matter where the bulb is in respect to the battery, as long as the circuit is complete, the bulb will light up.
Take a battery, a wire and a little light bulb. Put the wire on the flat part of the battery then put the other end of the wire on the side part of the bottom of the light bulb. Put the end of the light bulb on the top of the battery, dont touch the wire to the top when the light bulb is on it because is either shocks you or doesnt work.
I am going to assume you meant Three wires, Battery and Light Bulb. (punctuation and plurals are important) Hook the light to one post of the battery Hooked from the light to the item being tested (use the other light connection, not the one connected to the battery) connect the other end of the test item to the unused terminal on the battery. Light comes on means it conducts electricity No Light, it does not.