It is called refrigerant, major refrigerant is hydro fluoro carbon (HFCs).
The energy comes from the heat taken from the heat/energy inside of the refrigerator/fridge. A fridge takes heat energy from inside the fridge and dumps it outside the fridge into the the pipes on the back of the fridge and into the room.
help!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!:-)
to increase surface area
The purpose of heat tape is to maintain and control pipes and vessels. This also keeps the heat that is being radiated from the pipes and vessels inside.
Becuase when water freezes, it expands and burst the pipe from the inside.
Simply, because that is where the warmest air is, inside a refrigerator. Air rises as it's heated, as heated air is less dense than cold air.
The energy comes from the heat taken from the heat/energy inside of the refrigerator/fridge. A fridge takes heat energy from inside the fridge and dumps it outside the fridge into the the pipes on the back of the fridge and into the room.
It goes through the pipes
When you plug in your fridge, the electricity energises the freon in the copper piping, which then spreads all over the fridge cooling it down. The biggest pipes are at the top, which pushes cold air to the bottom. Doing so, the warm air is in turn pushed up and when it gets to the top, it is cooled by the pipes. The process is then repeated over and over and over. This is how the food is cooled in a fridge xxx
AnswerPumping nitrogen through refrigerant piping during brazing is an excellent practice. The reason is that nitrogen helps to prevent the buildup of oxide scale on the inside of the pipes during the brazing process. Refrigerant is a natural cleaning agent, and as it is being pumped through the pipes it will pick up the scale and contaminate the refrigerant. It is possible that this will damage to the compressor.
refrigerator
to measure inside diameters of pipes
no
the pipes dont need to be replaced, but your condenser should match the system. although, if your pipes are very old, they may be leaky, and new ones would make it more efficient
With a paintbrush.
A new refrigerator should ideally stand over night, to allow bubbles in the pipes to disperse.
The best way to clean out the inside of your custom motorcycle straight pipes is to remove the pipes and use a cleaning solvent and a rag with a long handled brush.