place the sample on the microscope slide and observe it.
Pond Water Preparation
Gently stir the jar containing the water sample in order to ensure uniform distribution of organisms in the water.
Using a dropper, place two or three drops of pond water at the center of a clean, sterile microscopic slide.
Place a clean, sterile cover on top of the water drop (This should be done carefully, placing the slide on one edge at a 45-degree angle and gently laying it on top of the water to allow for even spreading of the water sample and remove bubbles)
Touch a piece of blotting paper on one side of the slide to absorb any excess water.
Place the slide on the microscope stage for observation.
The procedure is for the sample to be suspended in ethanol, allowing lipids present to dissolve. The ethanolic solution is then decanted into water. Since lipids do not dissolve in water, when the ethanol is diluted, it falls out of solution to give an emulsion. b8d7e385-e2f2-47f5-8c06-26f0aee337b6 Y2:b8d7e385-e2f2-47f5-8c06-26f0aee337b6
Normally, a sample of water is put on a microscope slide and examined using the microscope.
I won't speculate . -Get a sample tested by a lab then you will KNOW
sucrose , glucose , protein , water
temperature ... and hydration
place the sample on the microscope slide and observe it.
immuerse it in cold water
The volume of a sample of water is 20 cm3. The mass of this sample is closest to
Yes!
Disconnect the pipe at source and cap
"Procedure" is basically a description of what you actually did ... not why, not what it means, just what you physically did. For example, something like "Water samples were obtained from local rivers. Each sample was filtered to remove large debris and a 25 ml aliquot from the sample was taken" followed by further description of what you then did to obtain the results (which you will list in a separate section).
Oxygen is just O and water is H2O
The procedure for ash content determination in food samples begins with the selection of a sample that is believed to be representative of the entire portion. Then, the food is vaporized by dry ashing causing all minerals and water to be burned off.
we can get clear water from a given sample of a muddy water by the method of decantation.
A sample of water is said to be hard when it does not form lather readily with soap.
rain water
procedure for help boat float in water