0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you test ignition coils 1992 mustang 2.3?
The easiest way to test ignition coils on a 1992 Mustang 2.3 is to use an ohmmeter on the leads going into the coils.
How can the cathode end of a zener diode be determinded using an ohmmeter?
Hard to do. If your Ohmmeter battery is just 1-1/2 volts, then you simply put the test leads on the diode one way, then the other way. The way that show a meter reading will have the black lead on the 'cathode', if you assume, as most do, that electrons are issued from the " - " or 'minus' side of the battery. BUT . . . if your Ohmmeter voltage is above the zener's trigger voltage, then you will get a reading both ways.
What tool can be used to test for electrical conductivity?
The easiest way is to use an Ohmmeter. This function is usually built into most multimeter that can be bought at any hardware store. An Ohmmeter measures the electrical resistance of a material. The lower the number the more conductive that material is. If the Ohm reading is above the maximum reading on the meter then their is infinite resistance which means that the material is not a conductor of electricity.
How do you find the correct answer in a multiple choice test?
r u insane?? a test is still a test. there is no way. u have to study like for a regular test. if they were designed that way there would be no point
How can you chack the cdi an altcrnator?
One way to check the CDI on an alternator is to use an ohmmeter. If you do not know how to use an ohmmeter, you may be better off by taking your vehicle to a repair shop to look at the alternator.
How do you test coils on a Ford 5.4 expedition?
Refer to autozone.com . They have a comprehensive guide to the proper way to test and the correct resistance.
How can you tell if fuel pump relay is bad on 95 gmc safari?
In order to test the fuel pump relay, you must check that the two control circuit terminals on the relay are not connected, using an ohmmeter. You must also test the power circuit terminals on the relay, in the same way.
Why do you get a a on a test you gussed on?
maybe you Guss all right and maybe they were correct you are luck very and it hard to get A+ on test you Guss on enty way
How do you check if injector is firing or not?
There are several ways. Most people use what is called a noid light. To use a noid light you unplug a fuel injector and plug a noid light in to the harness. You turn the engine over. If the noid light flashes then you have injector pulse. Another way to check is to use a low wattage test light. Unplug a fuel injector, and plug one end of the test light to each wire from the harness. Crank the engine over and see if the light flashes.
If i do a pregnancy test 7 days after i was due on my period will the test results be correct?
you can never be sure with a home pregnancy test, you can do that, but the only definite way is to see a doctor
How test resistances?
we can measure the resistance if we know the voltage and current passing through a line (V=IR)AnswerYou can measure its approximate resistance using an ohmmeter, but ohmmeters aren't particularly accurate. A better way would be to use a Wheatstone Bridge, which is highly accurate.
Which is the correct way to hold a test tude while heating its contents?
The correct way to hold a test tube while heating its contents is to use a test tube holder or tongs. This ensures a secure grip and protects your hands from potential burns or accidents. Avoid holding the test tube directly with your bare hands as it can become very hot.
