0
What else can I help you with?
What is the cost to replace an intake valve on a 1998 Jeep Cherokee and a 2001 Ford Explorer?
As the jeep is very old so it might cost INR 40000 - 50000 and for ford it must be 10000 INR less
How do you tell difference between exhaust valve and intake valve on 1998 suburban 5.7?
The intake valve is bigger.
How do you replace the water pump on a 1998 Jeep Cherokee 4.0L V6?
my jeep Cherokee 1998 4.0 is a straight 6
How do you replace the heads on 1998 S10?
I replace the heads with first starting by draining the coolant then removing the exhaust as neccasary then the intake manifold and distributor then the valve rocker arms and pushrods then unbolting the heads.
Where is the MAF sensor on a 1998 Jeep Cherokee?
A 1998 Jeep Cherokee does not have a mass airflow sensor. It uses a manifold pressure sensor, MAP, which is on the rear of the intake manifold.
Where is the PVC valve on a 1998 Toyota Corolla?
The PCV valve on a 1998 Toyota Corolla is located on top of the engine, on the passenger side. It connects the intake manifold with the valve cover.
Where is the EGR valve located on a 1998 Ford Explorer?
On a 1998 Ford Explorer, the EGR valve is located on the intake manifold. It is behind the throttle body.
How to replace air vent switch for a 1998 Toyota Camry?
how to install replace air intake hose toyota camry 1998
Where is the PVC valve located on a 1998 Nissan Quest?
It's on the back of the intake plenum.
How do you change a PCV valve on a 1998 Monte Carlo?
The PCV valve for a 1998 Monte Carlo should plug into the valve cover. Twist and pull it to remove and replace it.
How do you replace egr valve 1998 mercury mystique?
To replace the EGR valve on a 1998 Mercury Mystique, first, ensure the engine is cool and disconnect the negative battery cable. Remove any components obstructing access to the EGR valve, such as the air intake duct. Unbolt the EGR valve, disconnect the vacuum hoses and electrical connector, then install the new valve in reverse order, ensuring all connections are secure. Finally, reconnect the battery and start the engine to check for proper operation.
How do you replace egr valve on I30 Infinity 1998?
To replace the EGR valve on a 1998 Infiniti I30, first ensure the engine is cool and disconnect the negative battery terminal. Remove any components obstructing access to the EGR valve, such as the intake manifold or hoses. Unscrew the EGR valve from its mounting, clean the mounting surface, and install the new valve with a new gasket. Finally, reassemble any removed components, reconnect the battery, and start the engine to check for proper operation.
