Want this question answered?
how do you replace rear door lock assembly on 92 pONTIAC tRANSPORT
Replace your ignition lock assembly.
You have to take off the plastic surround around the handle for the tail gate then pull the two silver rods toward each other or toward the handle and the gate will come down. Most likely the spring has broken or the lock stop and the kit to replace the whole latch assembly is about $35.00.
If the lock cylinder is faulty, the entire steering column lock assembly will have to be replaced. reference " Haynes Repair Manual"
The headlight assembly (aka the headlight bucket) is removable by releasing the lock tabs behind the assembly. Once the assembly is wiggled out in the open you can easily replace the bulbs.
* Remove the trunk lid latch * Detach the lock release box from the latch assembly * To detach the lock cylinder from the trunk lid pry off the retainer
Remove the panel behind the latch then remove the clip from the lock and it comes right out, it isn't connected to any mechanism inside the tailgate.
The gate code for lock box in Tyler Texas is not static, it is dynamic.
Remove the screws holding it in. Push the assembly forward and pull it out from the door. Remove the two metal bars from the back of the assembly. Reverse for installation
Replace just the steering lock unit. The tumblers are old, and they need to be replaces. After replacing the lock, go to a locksmith, and have him re-key the doors to match your new ignition lock.
auto lock actuator. If it will close but not open. If it will close I bet you won't here it lock. The part is a dealer item and cost $110.00.
how do i replace a trunk lock with another lock that has a key