answersLogoWhite

0


Best Answer

Replace your ignition lock assembly.

User Avatar

Wiki User

โˆ™ 2006-04-06 04:14:47
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: What do you do if the key is stuck in your Acura Vigor switch?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Art & Architecture

Why escalade ignition switch does not turn?

The tumblers in the key cylinder have most likely become stuck in the wrong position and you will have to replace the ignition key cylinder.


Key is stuck in the ignition of 00' Volvo s40 and will not turn off to take key out?

Hi I had this problem on my V40 & it was the the small park release switch on the autotrans selector it gets stuck half way down &key wont bugde till its up


89 Jeep Cherokee Laredo Ignition key stuck in on position This is the second time last time cost 150 then after the warranty was up got stuck again?

In my case it was the ignition switch itself had overheated and seized up. Replace the switch (have to lower the column, disconnect the wiring plug from the switch, and remove/replace the switch.) Clean all connections to the switch, make sure they're connected solidly and not heating up again.


300E Why is the key stuck on the ignition mode Lights appear but car will not turn on.?

Neutral safety switch ANSWER 2 Try hitting your steering wheel hard to the right :) Smack it really hard and try taking your key out again. There is a safety thing in there which sometimes needs a good smack.


How do you unlock the steering wheel on a 91 Lincoln Continental without a key?

hopefully your not stealing the vehicle. but you will have to remove the steering wheel and then remove the key switch itself, purchase a new key switch and replace. However if its only to move the vehicle, after you remove the key switch you can take a screw driver and turn the mechanism in the column to unlock.

Related questions

How do you remove ignition key stuck in Chevy colbalt?

how to remove key stuck in ignition switch in Chevy colbalt


How do you reset your acura vigors alarm it wont stop going off and wont start?

Put the key back in the door and turn it. This works for my 94 vigor.


Jaguar xjs 1994 transmission stuck in park?

Wiggle the key as you turn the key while in the ignition switch. My 1994 gets stuck about once a month.


Can a bad ignition switch cause the key to get stuck in ignition?

No, the ignition switch is not located in the tumbler assembly. If the key is stuck try turning the steering wheel each way while at the same time turning the key. If it will not come out then something is wrong with the assembly.


How do you disable 1992 Acura vigor alarm?

I am a installer movil electronics yoghurt`s sound and to disable the factory alarm in 92 Acura vigor is to take-off the drivers door panel. It a 6 o 7 wires to run from the door key cylinder grab the wire green/black and grounded that`s it.


How do you disable 1992 Acura Vigor gs alarm?

I am a installer movil electronics yoghurt`s sound and to disable the factory alarm in 92 acura vigor is to take-off the drivers door panel. It a 6 o 7 wires to run from the door key cylinder grab the wire green/black and grounded that`s it.


Ignition switch stuck on?

If it is stuck on completely so that the engine will not shut off, it is either the key switch or the ignition itself. Depending on the make of car, the electrical part of the switch is either on the key part or lower down on the column and activated with a rod. If the key will not turn all the way back so that you can remove the key, the transmission may not be completely in park. Hold pressure on the shifter and try turning the key.


Why does your car want to start as soon as battery is connected without key in ignition?

Stuck ignition switch.


How do you change the key cylinder of the ignition switch in a 1991 acura legend?

Remove the retaining ring at the top of your 1991 Acura Legend ignition switch. The ignition switch cylinder will slide out. Remove the wiring harness from the end of the ignition cylinder. Reverse the process to install your new ignition switch cylinder.


What could be the reason for the key getting stuck in the 'on' position of the ignition in a 2003 Lincoln Navigator?

the tumblers in your key switch are failing replace them before long


Why escalade ignition switch does not turn?

The tumblers in the key cylinder have most likely become stuck in the wrong position and you will have to replace the ignition key cylinder.


93 s10 blazer motor spining over with key is off?

Starter solenoid switch is stuck closed.

People also asked