0
What else can I help you with?
How to remove the universal joint on a 1983 dodge 250 van?
you need to remove the circlips holding the cups in place in the ears of the ear of the ujoint. Set the ujoint on its side and place a pipe or large socket under neath such that the ujoint cup will slip inside the pipe. Place a smaller socket or peice of pipe (exactly the same size as the cup on the top side of the ujoint and give it a few sharp raps with a heavy hammer. May need to use penetrating oil and or heat to break it loose. Dont pound on the ujoint cups directly with the hammer. you will break em. also make sure the pipes or sockets are just the right size. You will destroy the yokes of your drive shaft if you pound on it with the wrong sizes. Of course you could get the right tool from your local part source or auto zone for no charge but it isn't as fun!
Why does the rear ujoint keep blowing out from the driveshaft to the axle?
A worn pinion flange or the drive shaft where the u-joint goes in these holes may be wallered out some
Is the main land cover around the arctic ocean?
what is the main land cover around the arctic ocean
How do you tighten a valve cover?
There are valve cover bolts around the perimeter of the valve cover. You want these tight but not as tight as you can get them.
Why does your Chrysler sebring have oil on one of the plugs?
The seal under the valve cover around the plug tube has failed.The seal under the valve cover around the plug tube has failed.
How do you put on a steering wheel cover?
It just stretches around the wheel. Carefully wrap it onto the wheel clockwise and counterclockwise stretching the cover around the steering wheel. Make sure that the cover does not slip. When you turn the wheel, you want to turn the whole steering wheel and not just the cover. Therefore, you want it to be tight. If it slips, wrap a thin cord tightly around the cover.
How do you put on steering wheel cover?
It just stretches around the wheel. Carefully wrap it onto the wheel clockwise and counterclockwise stretching the cover around the steering wheel. Make sure that the cover does not slip. When you turn the wheel, you want to turn the whole steering wheel and not just the cover. Therefore, you want it to be tight. If it slips, wrap a thin cord tightly around the cover.
How do you know you have a bad ujoint on a 2000 ford ranger?
Check for looseness or play in the joint Do you hear a "Ping" when shifting from Park- Drive or Reverse? Do you hear a "Squeak, Squeak, Squeak" when driving down the road?
How do you fix the front drive shaft on your 1996 Chevrolet Silverado?
Assuming you need new U-joints on the shaft I will try to explain... First remove the bearing retaining u bolts from front differential and the tranny. Be careful while separating the shaft from parts( you may have to use a pry bar) that the bearings do not fall out of the cups. There are snap rings on one side of the U joint, remove those with a pair of needle nose pliers and then prop the shaft on a 2x4 or something and pound out the old ujoint with a ball peen hammer and a socket so you do not bend the shaft where the ujoint is in. Once you have it loose wiggle it out and reinstall the new ujoint but do NOT pound it in with the hammer you'll end up damaging the new bearings, repeat with other side if needed. Hope this makes sense and helps you out.
The length of a cover letter should be concise about to paragraphs?
The length of a cover letter should be around 2;3 paragraphs.
Skweaking rubbing grinding noise coming from what seems like the tcase area Thought it might be a ujoint greased it didn't work Any thoughts?
Does it only make noise when in 4x4 mode or all the time?
Who is the guy with the bandanna around his neck on the cover of 21st century breakdown?
He does not have a bandanna around his neck
