Lowest belt driven pulley on engine
Are you sure you need to replace it? Is it a no-spark condition? Might want to check the Crankshaft Position Sensor first.
No Chrysler does not use reset buttons.
That would be the crankshaft pulley.
It is on the front of the crankshaft, under the timing belt.
It is top rear of the bell housing.
It is inside the HVAC housing under the dash.
Chrysler Cirrus was created in 1995.
The oil pump is behind the timing belt on the front of the crankshaft.
the crankshaft sensort is at bottom under the distrbutor it is way down there by the trans housing.
If the radiator fan does not shut off on a 1996 Chrysler Cirrus, the fan relay might be bad. The fan relay is usually located in a bank of relays near the battery.
It is fairly difficult to change a water pump on a Chrysler Cirrus. First, you remove the crankshaft pulley, remove one engine mount, take off the timing belt, and finally gain access to the pump. You can then feel free to switch them out.
Are you sure you mean 2002 Chrysler Cirrus -- they quit making the Cirrus in 2000. It is now a Sebring