If the voltage is 500 volts, and the power is 200 kilo-watts, then the current is 400 amperes. (Watts equals Volts time Amperes)
The resistance of the conductor has nothing to do with this calculation, but that fact that the conductors are 0.1 ohms means that the voltage drop across each conductor is 40 volts. (Volts equals Amperes times Ohms) Since there are two conductors, the total voltage drop is 80 volts, and the voltage available to the load will be 420 volts.
All of them. That's the definition of "conductor".
If all environmental conditions remain constant then the resistance will not change appreciably with applied voltage, but the current will increase. An increase in current will raise the temperature of the conductor which will increase the resistance somewhat.
we can calculate the current in a commmon electrical circuit by this formulae i.e,I=V\R where i is the current flowing in the conductor, R is resistance , V is the voltage.. THE FORMULA IS CORRECT but the term conductor does not suffice an explanation since a conductor is low in resistance R= resistance not conduction.
That is the resistance, measured in ohms.
It depends on whether the material is ohmic or non-ohmic.If it is ohmic, then it will obey Ohm's Law, and its resistance will remain constant if the current decreases.If, on the other hand, it is non-ohmic, it will not obey Ohm's Law and, if the temperature of the conductor falls (assuming it is a metallic conductor) due to the fall in current, then its resistance will fall too.
The only limit on how much current the conductor can carry, regardless ofthe weather, is the amount of current that causes the conductor to melt.The current in such a conductor depends on the voltage between its ends,and on the resistance of the conductor. The resistance of the conductor issomewhat less when it's cold, so a given voltage would result in more current.
4
I assume you meant pressure to voltage. The resistance of a conductor is directly proportional to the temperature of the conductor. If the temperature of the conductor increases due to increased current, then the resistance tend to increase too.
The heating effect of current refers to the phenomenon where the flow of electric current through a conductor leads to the production of heat. This occurs due to the resistance offered by the conductor to the flow of electrons. The amount of heat produced is directly proportional to the square of the current and the resistance of the conductor.
resistance will be high
It is a conductor, it conducts the electric current generated to the load that is being supplied with power.
Opposition of the conductor to the movement of current.
Resistance is the opposition to the flow of electric current through a conductor. It is defined as the ratio of the potential difference (volts) between the ends of the conductor to the magnitude of the current (amps) through the conductor.
The "current" through any conductor is voltage across the conductor/conductor's resistance .The current is measured in "Amperes" (amps)."MA" stands for "Milliamps". There are 1,000 of those in one whole ampere.So, the current through a conductor is1,000 times the voltage across the conductor/conductor's resistance . . . in MA
Resistance is the hindrance a conductor creates to the flow of electric current
In general, yes, it does. For example, if you move a conductor in a magnetic field, this will induce a certain voltage between the extremes of the conductor; the corresponding current will then depend on the resistance.
Resistance is the opposition to the flow of electric current through a conductor. It is defined as the ratio of the potential difference (volts) between the ends of the conductor to the magnitude of the current (amps) through the conductor.