0
3F0 - 3F7Primary floppy disk drive controller. Primary IDE controller (slave drive) (3F6-3F7h)
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What is Primary IDE Channel?
The Primary IDE Channel component provides the IDEport driver in the atapi.sys file.The IDE port driver is part of the IDE driver model in Windows 2000
What are the four possible configurations for four IDE devices in a system?
Primary IDE Channel , Master Device Primary IDE Channel , Slave Device Secondary IDE Channel , Master Device Secondary IDE Channel , Slave Device
What does the CD driver card do?
CDROM drives dont normally require a "driver card" as they are IDE devices which plug into the motherboards built-in IDE controller.
What is SCIS?
SCSI is a type of interface used for computer components such as hard drives, optical drives, scanners and tape drives. It is a competing technology to standard IDE (Integrated Drive Electronics). While the less expensive IDE technology is built into motherboards, SCSI is a technology that must be added by purchasing a SCSI controller. The SCSI card fits into an internal PCI slot. SCSI devices are then connected to this card.
What is the difference between PATA and IDE?
Not much. Different name mostly.
What is the standard IRQ setting for primary IDE controller?
14
What should the replacement optical drive be on the primary IDE controller?
If replacing the optical drive on a primary IDE controller, it is important it is compatible with the CD Rom drive. The IDE data cable must be connected and you must have the power cord plugged in.
How many IDE controllers are typically built into an ATX motherboard?
it has 2 IDE controller
What is an IDE controller?
IDE (Integrated Device Electronics) is a standardized interface for data storage devices in computer systems. It is so named because much of the logic circuitry is integrated into the device itself. IDE is most commonly used for hard drives and CD or DVD drives, but has also been used for tape drives and zip drives. An IDE controller is the primary interface (usually integrated into the motherboard) which any IDE devices will be plugged into. It handles the flow of data to and from these devices. It usually consists of two connections (known as IDE channels) both of which can handle up to 2 devices each. It is also possible to add more IDE controllers in the form of PCI or PCI-E cards, these are usually referred to as IDE controller cards. This is often done to enable more storage devices to be installed into the system, but may also be done to replace an obsolete or malfuntioning on-board IDE controller.
What is Primary IDE Channel?
The Primary IDE Channel component provides the IDEport driver in the atapi.sys file.The IDE port driver is part of the IDE driver model in Windows 2000
What are the four possible configurations for four IDE devices in a system?
Primary IDE Channel , Master Device Primary IDE Channel , Slave Device Secondary IDE Channel , Master Device Secondary IDE Channel , Slave Device
How many devices can be added to a typical IDE controller?
4
How many types of primary IDE?
there is IDE and EIDE. It is basically not that common these days.
How else could you do the job that the disk controller does?
if your refering to IDE or SATA controller mostly likely using IDE or Sata ports on the board else u could go external by USB disk controller is recognised in BIOS under an IRQ
What is the IDE channel to connect hard drives?
The best IDE channel to connect on a hard drive is the Primary IDE channel, Also known as IDE 1 in dell computers
What does the CD driver card do?
CDROM drives dont normally require a "driver card" as they are IDE devices which plug into the motherboards built-in IDE controller.
What should the primary jumper be set to On a primary IDE channel if a single hard disk is attached?
master if the ide cable has a single drive connection. if the ide cable has the master and slave connection. then set the drive to master with slave.
