Primary IDE Channel , Master Device
Primary IDE Channel , Slave Device
Secondary IDE Channel , Master Device
Secondary IDE Channel , Slave Device
Conventional PCI now has four types of slots and six possible PCI card configurations to use these slots
Arithmetic and logic unit (ALU)Control unitMemoryInput output devices (collectively termed I/O)
One is a ground bracelet, two is a ground mat, three is static shelding bags, and four is antistatic gloves.
hardwere softwere people data
Any peripheral that receives and/or displays output from a computer. Below are some examples of different types of output devices commonly found on a computer.MonitorPrinterSound cardSpeakersVideo card
The system will be able to support 4 EDIE devices, 2 devices per cable.
Conventional PCI now has four types of slots and six possible PCI card configurations to use these slots
Short answer: Four A much more precise answer: The IDE standard allows for two devices to share a single IDE channel. The most common configuration is for there to be two IDE channels on the motherboard, allowing for a total of four devices. It is possible however, to add more IDE channels, usually in the form of PCI add-on IDE controller cards and have literally dozens of IDE devices in a single computer system.
The major system resources to consider are the I/O port address, memory addresses, IRQ, and DMA settings.
Primary Master Primary Slave Secondary Master Secondary Slave Primary or Secondary will depend on which cable are you using to connect the drive. Master or Slave will depend on the drive's jumper configuration.
It's not possible. it lasts longer in your system than anything else out there.
Four, two per connection. Each cable has a master and a slave, so pay attention to jumper settings when connecting the devices.
KEYBOARD
There are only four different configurations.
Four H0 channels Three H0 channels and a D channel One H10 channel and a D channel One H11 channel
IDE (also known as PATA and ATA) provides for up to four devices, including the hard drive. The serial ATA standard allows for more than four drives installed in a system.
One. SATA interfaces are USUALLY only one device at a time. It is possible, if the controller supports it, to use a port multiplier which allows you to use four devices off one port .