About 20 years.
92-97 Seville
The 1992 Mercedes-Benz 300 rear bumper is held in place with eight retaining bolts. You can remove the rear bumper by removing the retaining bolts.
There is a difference. The 1992 front bumper has a more rounded look than the 1991 model but it should fit. Not 100% sure about that but I suspect they should both bolt on the same.
High tone under bumper on driver side...low tone under bumper on passenger side...front bumper.
no
yep
one is a classic , the other isn't , duhhh
Just a few bits of trim and accessories.
No appreciable differences
First, remove the nut from the middle of the bumper, and then remove the nut from the the mounts at each rail frame. Then remove the nut or screw holding the bumper to the car at the area of the wheel. Remove the old bumper, put on the new bumper, and replace the screws in nuts in the reverse order.Ê
To remove the front bumper from a 1992 Acura Vigor, start by disconnecting the battery for safety. Then, remove any screws or clips securing the bumper, typically found near the wheel wells and underneath the vehicle. Carefully pull the bumper away from the body, ensuring to detach any electrical connections for fog lights if equipped. Finally, lift the bumper off its mounting points to complete the removal.
1972, 1976, 1980, 1984, 1988, 1992, 1996, 2000, 2004 and 2008.