In an open circuit, electricity stops. Closed circuit, electricity goes. Therefore, in an open circuit, the electrical appliance cannot work, but in a closed circuit, the electrical appliance can work
Open Circuts are incomplete and Closed Circuts are complete and they let electrons flow through them.
Checked by MacMillian MaGraw Hill Science Book.
closed circuit often called short circuit it means connecting two teminal of a circuit usually plus and minus without resistanace or any component
just you have to join
open circuit means disconnection between plus and minus
dont beak your head for this
its easy
ma leish habib i!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
In an open circuit, the switch is "open" or in the off position. No electricity flows and nothing happens.
In a closed circuit, the switch "closes" the gap and allows electricity to flow. Now it's "on."
While ckt is open there is no current flow in the ckt. But when there is a close ckt then current is pass through the ckt from higher potential to lower potential.
CommentThe correct term is 'closed circuit'.
in open circuit there is no current flow.in closed circuit there will be current flow
they are circuits
By looking at both open and closed circuits capabilities
If the circuit was open, the tram's motor could not run!
A closed circuit is a kind of electric circuit in which the path that the electrons follow forms a complete circuit.
This is copied from Section 6.11, Question 8 in "Modern Refrigeration and Air Conditioning." The answer is (B), "The open circuit prevents flow. The open AEV allows flow to occur." Although a bit obscure, the answer is correct because, within the context of an electrical circuit, an "open circuit" (i.e. disconnected wire) would prevent the flow of electrical current. Within the context of a refrigeration circuit, an open AEV (automatic expansion valve) would permit the flow of refrigerant into an evaporator coil to provide cooling.
no because when you close it, the circuit is complete so it lets the electrons pass through
Type your answer here... Extrusion is the open die punching process whether forging is close die punching process.
A light switch
electric potential is potential difference between two points in closed circuit. but electromotive force is potential difference in any open circuit.
TO open and close so that we can make it complete
Close it!!
If the circuit was open, the tram's motor could not run!
One can close an open circuit by adding a complete loop of wire. This will allow the electricity to flow through the circuit, while electricity will not flow in an open circuit.
To open and close the circuit.
To open and close the circuit.
A pit is open, whereas a mine has a ventilation circuit.
It open and close it
The device is called a switch.
A basic manual operating switch is able to open or close a circuit. There are electronic components that will also control the working of a circuit.