For home units, the compressor is the outside, large box shaped unit that is usually on the side, or behind the house. It takes the freon gas from inside the home compresses it into a liquid, where it will be pumped back inside to the condensor. Compressing gas creates heat, so a fan draws air through the cooling coils on the side of the unit, and blows it out the top. It is important that these coils are kept clear of debris, and should be periodically sprayed off with a hose to knock off dust that may have accumulated.
Now that the freon gas is compressed, it gets pumped inside the house to the condensor, where the pressure falls, allowing the freon to return to a gas. This creates an endothermic reaction, drawing heat from the air. The condensor unit has a series of coils with fins that get very cold. The warm air in the house is blown over these coils, cooling it, and then through the ductwork of the house, and out through the registers.
Pump is used to increase the pressure of incompressible fluids (i.e., density is constant for change in pressure)
Compressor is used to compress the pressure of compressible fluids (i.e.,density varies with pressure)
The basic difference between a pump & compressor is : compressor is used to compress air at high pressure ,also when there is no load requirement .But in the other hand pump is used to deliever fluid or water to high head or through long distance under high pressure.A pump can't be used to compress air... By :Rahul J Malaviya
condenser is a device or unit used to condense vapor into liquid. were A chiller is a machine that removes heat from a liquid via a vapor-compression or absorption refrigeration cycle. This liquid can then be circulated through a heat exchanger to cool air or equipment as required.
air condenser can be used when boiling point of solvent is very high, while water condenser can be used generally when the boiling temperature of a solvent is less.
what is th different between end suction pump and singl stage pump and multistage pump
the ammonia compressor differs slighlty from the air compressor in the fact that one uses a piston to create airable pressure frence while the outher uses a weighted fan atached to a fly wheel,eather would blow well
it runs without fluctuation i.r continuous flow......
If the fan outside is not running the compressor will overheat and if the fan inside the house is not running the compressor will get liquid refrigerant back to it and lock up! Neither is good for the compressor.
A sump pump is submerged in a pit. It keeps house from flooding. A utiliity pump is used to pump water out of already flooded house, boat, pool, tank, etc....
what is difference between dynamic and volumatic compressor
pump is used to handle liquid and compressor is used to handle gases. other difference include blade shape etc..
pump is used to move liquid from one point to another, while compressor is used to compress and move gases from point to point.
The only one difference in b/w compressor and pump rotor is impeller shroud width.Fluid is incompressible so impeller shroud width is not change and gas is compressible so impellers are tends to thin in width to the discharge side.
Pump relay is used to increase the pressure of incompressible fluids (i.e., density is constant for change in pressure) Compressor relay is used to compress the pressure of compressible fluids (i.e.,density varies with pressure)
pump is used to move liquid from one point to another, while compressor is used to compress and move gases from point to point.
A rotary compressor has screws or gears that compress a gas. A reciprocating compressor has a piston in a cylinder compressing the gas.
they have different names A Pump is a mechanical device which transfers Liquid from a lower point to a higher point.Eg: Centrifugal pump,Rotary pump,Reciprocating pump. A Compressor is a high pressure mechanical device which basically compressors air/gas Well, a compressor compresses a gas and a pump moves a liquid. Compressors are often used in refrigeration applications where gas is transformed into a liquid and vice-versa, so the main task for the compressor is not to move the gas but to compress it.
this tool is not available
what is difference between inhibitor and antagonist
There is no difference. A blower is just a term used for a supercharger. A compressor is any machine that compresses a gas for many different purposes. A supercharger in its many forms is a type of compressor
A serpentine belt is one belt that runs all engine accessories (i.e. power steering pump, ac compressor, water pump, AND fan). A fan belt runs the fan only.