spectrum analyser is single channel and cannot find ratio of phase and magnitude
Generally upstream is closer to the positive (+) voltage source. In the case of an NPN transistor upstream of the transistor is the part of the circuit from (+) to the NPN collector pin. Downstream of the transistor is from the NPN emitter pin to the ground / sink / negative (-) terminal.
If you take two different nodes in a network and if you find the difference in voltage for those nodes then it is known as potential or voltage difference. Here the reference is not taken. But if you find potential difference between a node and its respective ground it is known as voltage at that node here reference is ground potential i.e zero.Answer'Voltage' is synonymous with 'potential difference'; they both mean the same thing. And it is important that these terms are not confused with 'potential'. So, it is incorrect to say 'voltage difference' (which would mean 'potential difference difference'!), or to describe a voltage as existing 'at' a particular point, or 'with reference to', for example, earth or ground.In very simple terms, if two points are at different potentials, then there is a potential difference (or 'voltage') between them. A potential exists when work is done moving a charge to a particular point; the greater the work, the higher the potential. 'Potential' is roughly equivalent to the potential energy gained by an object when it is lifted against the force of gravity.Think of it this way: 'potential' is equivalent to 'height', whereas 'potential difference' (voltage) is equivalent to the difference between points at different heights.
In telecommunications, facility refers to the transport network (see http://en.wikipedia.org/wiki/Telecommunications_facility). In an optical transport network, facility would refer to the optical fibre plant. Terminal refers to the end equipment that is communicating over the transport network (see http://en.wikipedia.org/wiki/Terminal_%28telecommunication%29). Thus, in the context of optical transport equipment, a terminal loopback sends data received from the end equipment back to the equipment. A facility loopback sends data received from the transport network back to the transport network.
An electrical network is a system for supplying electricity in a given region.
it means network operating center engineer, one who operates network.
Network+ Answer: C. Spectrum analyzer
A network traffic analyzer is used for analyzing and monitoring the use of network traffic for many devices. Network Traffic Analyzer is also used to monitor the wireless network performance.
The Hewlett Packard 8510C network analyzer monitors the network parameters of electrical networks. It measures both the linear and non-linear actions of devices.
The main function of Protocol Analyzer are: •To monitor network traffic, •To analyze packets,. •To watch network resource utilization, •To conduct forensic analysis of network security breaches and, To troubleshoot network problems
Tracing network traffic requires a network monitor, protocol analyzer, or packet sniffer.
Protocol analyzer
social network
NetFlow Analyzer is a complete traffic analytics tool. NetFlow Analyzer leverages flow technologies to provide real time visibility into the network bandwidth performance.
AnswerThe difference between the two is that internet is the world wide web and network is local.
Traffic.
computers
recognize network communications issues and diagnose network communication issues