Want this question answered?
Yes
There is a real difference. A flame-retardant bedding has filler that is not flame resistant, but the outer later is flame resistant. As for inflammable bedding, both the filler and the outer layer are both flame resistant.
304 and 304L are stainless steel electrodes. but in 304L, L denotes Lower percentage of Carbon content.It improves the corrosion resistance character of filler wire.
Since the difference in volume corresponds to the volume of the stopper, the volume of the stopper=30.9-25=5.9ml Thus density of the rubber stopper=mass/vol=(8.46/5.9)g/ml
If there is debris on the stopper it might be preventing a good seal. Try removing the rubber stopper and wipe it off to remove any debris that might be on it. Clean out the hole that the stopper goes into as well. This will help ensure a clean seal between the hole and the stopper. Put the stopper back into the hole, making sure it is a tight fit. If it still leaks you may need to buy a new stopper.
Sand the fiberglass with a 400 - 1000 grit sandpaper so you can not feel a difference between the fibergass filler and the body of the car. Now you can prime it.
Between The Second And Thrid Fingers
Maintenance free batteries have no filler caps and you do not need to check the level nor add distilled water.
Sand the fiberglass with a 400 - 1000 grit sandpaper so you can not feel a difference between the fibergass filler and the body of the car. Now you can prime it.
The reagent bottle is not used for dropping, having only a common stopper.
it is stopper =]
between the secon and third finger