0
A Stroke of a crankshaft is determined by the "Distance" between the "center-point (CP) of Crankshaft(CRKST) to the center-point(CP) of Rod Journal(RJ)" where the big end of the Connecting Rod(CR) goes. the small end of the CR attaches to the Piston(PN) via a wrist pin. If that "Distance" is 2 inches(2.00) <a half-stroke> multiply by 2 = 4inches or a 4.00 Stroke, and this amount of full stroke usually gives good truck torque at low to mid RPM.
Now when the PN is both at Top Dead Center(TDC) or Bottom Dead Center(BDC), the
The Bore of a cylinder where the piston rides up & down(stroke) is measured by diameter, say 3-1/2(3.5) inches divided by 2 = 1-3/4(1.75) inches, is the center of your Bore and that lines up directly with the center-point of your CRKST, or a
Center-line crankshaft.
What else can I help you with?
Can you make a ford motor into a 383 stroker?
If you wanted to put a 3.75" stroker crankshaft with a with a 0.05" offset grind into a Ford engine with a 4" bore (such as a Windsor 351) you could make a 383ci Ford stroker. But as for making the traditional Chevy stroker engine, you can't turn a Ford engine into a Chevy engine.
What is the offset in a hexadecimal code?
The offset is usually the difference between the address of a module and the specific location being referenced.
What is frequency offset?
the difference between the source freq. and the reference freq
What is the difference between the input bias current and the input offset current?
A: difference in bias current causes the other
What is coarse frequency offset?
the frequency difference between the transmitter and the receiver without any noise or distortion
What is the Time difference between the UK and Venice?
UTC/GMT + 1 hour. (Offset 1 hour+ for daylight saving time)
What is the difference between offset and digital printing methods?
Offset printing is an indirect image transfer. This is common for putting a picture on cakes. Digital printing uses files and PDF's that are part of a software program. This is comon for printing pictures.
What is the time offset between tucson Arizona and Baghdad Iraq?
In the winter, there is a 10 hour time difference between Arizona & Iraq. 7 AM in Arizona = 5 PM in Iraq
What is offset voltage or currents?
the minimal difference of the two voltages
What is the difference between rims for front and rear wheel drive cars?
Sorry this is an incorrect statement : "there is no physical difference between rims on cars that are front vs. rear wheel drive. The differences lie almost completely within the drivetrain itself." Traditionally a RWD vehicle will take a rim of neutral to negative offset. A FWD vehicle takes a rim with positive offset.... the confusion is with new RWD ie late 80's on rwd as they have tended to be positive offset at well... eg late model Corvette/Camaro/Mustang It all relates to OFFSET
What is the difference between a regular club face and an offset one?
the leading edge (bottom) of a regular club is flush with the position of the shaft. An offset club's edge is set a bit back, giving you more time to square the club at impact. Helps the slice.
What is the difference between oblique offset and perpendicular offset?
The measurements are taken at right angle to the survey line called perpendicular or right angled offsets. The measurements which are not made at right angles to the survey line are called oblique offsets or tie line offsets.
