The electric cooker cable is made thicker because it has to carry more current. If it were too thin it would heat up and perhaps melt.
Waveguides are used at higher frequencies where their loss is lower than coaxial cable. Coaxial cable is used at lower frequencies where waveguides are too large and heavy. Lastly Coaxial cable is also used at higher frequencies where some flexibility is required.
Usually it is produced from mechanical energy (movement), by a cable moving in a magnetic field. This will produce a voltage in the wire.
skin effect that happen because the current pass at the edge of the cable in the ac current because of the frequency but in the dc the current pass throw the whole conductor the franty effect the stray capacitor increase the voltage on the line due to light load and the
-- galvanized steel cable -- dyed silk cable -- fiber-optic cable
A Bathyscaphe (pronounced Bath-escape) is a specialized deep-diving type of submarine. a Bathysphere is a special deep duty version of a Diving Bell- is captive and controlled by a surface crane vessel- has no buoyancy, ballast tanks or the like- if the Cable snaps- it"s a long way Downnnnn! the Bathyscaphe, however can independently move, dive, surface and so on.
Difference between coaxial cable and STP cable used for computer networking?
More electricity needed by a cooker requires a thicker cable than for a table lamp.
how long distance of electric earth cable , between point or manhole ,what calculation to make good earthing in building how long distance of electric earth cable , between point or manhole ,what calculation to make good earthing in building how long distance of electric earth cable , between point or manhole ,what calculation to make good earthing in building
I assume you mean a cooker switch, which should be fed from a 40A MCB in the conmsumer unit and with 6mm cable
The difference between Armored cable and Metal Clad cable is that the MC cable has a EGC (Equipment Grounding Conductor). Both cables are armored, and look almost identical so watch out.
The difference between a cross cable and a state cable is that a cross cable, or crossover cable, is used specifically to connect two of the same devices.
DSL is considered to be broadband speed. There is a difference in speed between DSL and Cable. Cable is generally much faster.
A copper cable transports electrical signals. An optical cable transports light signals.
To answer this question the voltage of the cooker is needed.
The difference between 150 and 350 digital channel feed in the cable TV lies with the quality of the video.
Telephone is Cat3 while the cable coming form the modem is Cat5
Whether or not a network cable is connected to your computer.