Mnemonic means memory aid.
Instruction mnemonics are easy to remember short alphanumeric strings that stand for op codes.
Op codes are numbers that are understood by the computer and command it to perform various operations. They are usually inherently difficult for humans to remember.
What is difference between oppress code and operend
op code is used as the value of instruction . And operand is address location where the instruction can meet.
Each mnemonic maps directly to a machine instruction code, known as an opcode. Some mnemonics map to more than one opcode, however the instruction's operand types will determine which specific opcode will be generated.
In the 8085, the LDA instruction loads the accumulator from memory, while the STA instruction stores the accumulator to memory. LDA is a read, while STA is a write. LDA is opcode 3AH, while STA is opcode 32H.
The process of transferring instruction codes from memory location to instruction queue register is called opcode fetch.
In the 8085, the LDA instruction loads the accumulator from memory, while the STA instructionstores the accumulator to memory. LDA is a read, while STA is a write. LDA is opcode 3AH, while STA is opcode 32H.
The instruction opcode is a type of data contained in memory, pointed to by the PC (Program Counter) register.
The microprocessor uses an opcode fetch cycle for every instruction because it has to know the opcode in order to execute it, and that is located in memory.
IP is incremented after fetch of instruction opcode. Specifically, IP is incremented by the number of opcode bytes.
i) Instruction code deals only with mnemonics and its corresponding opcode but data code refers to your data like 10h which is always of 8 bits or a particular address say 8080h which is of 16 bits. ii) Data is your input to the instruction but an opcode is native to your machine. iii) Data is user specific instruction while opcode is machine specific instruction iv) You can alter data code but you cannot modify an instruction opcode.
In the 8086/8088 microprocessor, the code segment is used to fetch the opcode and any additional instruction bytes that might be part of the instruction, while the data segment is used to fetch and/or store any operand bytes that the instruction requires to be manipulated.This is in the case of no segment override prefix.
Symbols to represent instructions Each instruction (opcode) is given some mnemonic name Various addressing modes might select different opcodes for same mnemonic Symbols to represent labels and variables The addresses where variables are stored can be named Addresses in the code can be labelled