Max torque and breakdown toarque are the same...,.the point at which a motor will stop/stall.
There's a world of difference. A torque wrench is a hand tool used to tighten fasteners to a preset torque specification. An impact wrench is a power tool which uses power actuated hammers to tighten a fastener for high torque applications.
Torque is produced by a phase difference between two windings. The higher the phase difference, the higher the torque.The rotor rotates slightly slower than the magnetic field produced by the stator (the fixed winding). The difference in speed is called the slip and it allows low-frequency currents to be induced in the rotor and torque to be produced. For a motor rotating just below the synchronous speed, the torque is proportional to the slip which is defined by this, where Nis the actual speed and Ns is the synchronous speed:s = 1 - N/Ns
Induction motor is an AC electric motor which uses electromagnetic induction to induce the electric current in the rotor to produce torque.
A series motor is employed for traction application which has starting torque and permits intermittent operations by braking, which cannot be expected of a general purpose motor.
They are of similar design, but a fluid coupling simply transmits torque (with some frictional loss), while a torque converter amplifies torque, similar to a reduction gear.
One difference between dynamic torque and static torque is the level of difficulty to measure. Static torque is each to measure, while dynamic torque is not. This is because it requires a transfer of an electric or magnetic effect.
Torque and speed are inversely proportional
speed= distance per seconds & torque= revolution per seconds
The driver gear has the input torque, and the driven gear has the output torque.
Your question is wonderful .... But we are not intelligent enough to answer it ....
Difference between Torque and load
More bottom end torque!
Electromagnetic torque and load torque are different.Electromagnetic torque is the torque that is produced inside the machine which makes the machine rotate,while load torque is the torque that is applied externally with brake drum and and spring balance.Electromagnetic torque can be varied by varying the speed of the machine,but load torque is fixed.
In simple terms, torque gets you moving and power keeps you moving. In other words, your acceleration is dictated by the torque your engine provides and the top speed is limited by the power.
An electric motor can power anything that needs mechanical torque.
The pullout torque is the maximum torque a motor can achieve. Also known as breakdown or peak torque. It occurs at the point where, the increase in the rotor current is exactly balanced by the decrease in the rotor power factor.
The torque needed to loosen a bolt or joint is often much higher than the torque needed to put the bolt in in the first place. There is no set value difference between the two, unfortunately.