I think torsional strain happens only when two groups are eclipsed in relation to their positions to each other. This strain can be relieved by rotation about the carbon carbon bond.
But steric strain can happen all the time. (when two groups are eclipsed, gauge or staggered in relation to each other.)
no
The normal strain is a deformation caused by normal forces such as Tension or Compression that act perpendicular to the cross-sectional area, while the shear strain is a deformation obtained from forces acting parallel or tangential to the cross-sectional area.
Strain gage and Extensometer both are same purpose to check the stress and strain in selective test pieces, but traditional they were using strain gage its take the preparation time is high and Extensometer we are check the directly both results are same.
proportional limit is value of stress that beyond which it is nonlinear; prior to that the stress strain diagram is a straight line. At yield, the material strain will not return to zero after unloading and have a permanent set
Young's modulus
Van der Waals strain is one example
The anti-conformation of a Newman Projection is a conformation where there is not torsional strain due to steric hinderence. This is acheived by pacing the R (organic) groups far apart, on apposing sides. H R H \ | / o / | \ H R H
"Torsional strain" is the strain induced by applying torque. Basically, it is the strain imposed on a body by twisting it. (Such as the strain that a bolt endures when you use a wrench on it.)
When ever you cross a bridge torsional strain is at work, the engineers utilized it to determine the payload of each bridge and your car creates torsional strain on the bridges members.
It is what prevents DNA from torsional strain or winding up tightly.
no
there is no difference
difference between Strain-stress diagram of copper and steel?
Strain is the measure of length change per unit length. Elongation usually refers to strain under load at failure point.
Strain is further division of species and different in gentics level with other strain while clone is genticially and morphology similar to parent cell
Strain gage and Extensometer both are same purpose to check the stress and strain in selective test pieces, but traditional they were using strain gage its take the preparation time is high and Extensometer we are check the directly both results are same.
Strain gage and Extensometer both are same purpose to check the stress and strain in selective test pieces, but traditional they were using strain gage its take the preparation time is high and Extensometer we are check the directly both results are same.