answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: What is the differrce between w5w bulbs and 194 bulbs?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Physics
Related questions

What bulbs are holden astra park lights?

they are 12V w5w 5W bulbs.. hope that helps


Can you change a W5W sidelight bulb for an led bulb?

Yes, you can. There are 12v LED bulbs available in W5W fittings that are a direct replacement for most purposes. They are also known as 501 Capless. See http://www.autobulbsdirect.co.uk/501-w5w-led-bulbs-for-cars-and-vans/ for quite a few in different colours.


What is the bulb type for Toyota Paseo 1997?

Headlights - H4 Side repeaters - 10mm W5W Trunk - 10mm W5W Foglights - H1 Parking lights - W5W Indicators - P21W Taillights (stop lights) - P21/5W Taillights (indicators) - P21W Reversing lights - P21W Licence plate light - W5W Spoiler brake light - P21W from: (http://www.socaltercel.com/riko/Paseo%20&%20Cynos%20catalogue3%20-%20Exterior.pdf)


How do you replace a Citroen Picasso sidelight?

Locate the bulb holder under the bonnet, then turn the bulb by about a quarter and pull out. Replace with the same bulb (W5W 12V)


What are the bulb types in a 2007 outlander?

Bulb capacityWhen replacing a bulb, use a new bulb with the same wattage and colour.OutsideHeadlamps (high beam): 60 W (HB3)Position lamps: 5 W (W5W)Headlamps (low beam) < Halogen bulb >: 51 W (HB4) < Discharge bulb >: 35 W (D2R)Front fog lamps: 55 W (H11)Front turn-signal lamps: 21 W (WY21W)Side turn-signal lamps: 5 W (W5W)High mounted stop lampand Rear turn-signal lamps: 21 W (WY21W)Rear fog lamp (driver's side): 21 W (W21W)Tail lamps / Stop lampsand Reversing lamps: 21 W (W21W)Licence plate lamps: 5 W (W5W)Codes in parentheses indicate bulb types.InsideLuggage room lamp: 8 WRoom lamp (rear): 8 WMap & room lamps (front): 8 WFoot lamps: 1.4 WCentre console down lightand Lower glove box lamp: 1.4 W


How do you change the right front position light on 2007 saab 9 3?

Open the hood, remove the rubber cover for the high beam bulb (inboard bulb, closer to the radiator), remove high beam bulb and next to it inside the light assembly is the position light bulb. Using a pair of long and 45degree needle nose pliers gently grab the position light bulb socket and pull it straight out! Do not pull on wires and I had to remove my air filter box cover to get my big hands behind the light assembly! Bulb is a W5W, buy it before starting this job!


How do you change the right front POSITION light on 2007 Saab 9-3?

Open the hood, remove the rubber cover for the high beam bulb (inboard bulb, closer to the radiator), remove high beam bulb and next to it inside the light assembly is the position light bulb. Using a pair of long and 45degree needle nose pliers gently grab the position light bulb socket and pull it straight out! Do not pull on wires and I had to remove my air filter box cover to get my big hands behind the light assembly! Bulb is a W5W, buy it before starting this job!


How do you change a headlight bulb on a citroen c5?

There is not a lot of room to move especially where the battery sits. It isn't essential to remove the battery, but try changing the other side first. And wait until the engine and bulbs are cool. You'll be doing this by feelAll directions are as if you're looking from the front. (Normally, directions are as if you are behind the wheel.)1. Remove the plastic covers from the hydraulics and the battery.2. Reach in from the side and locate the two round covers. (If your arms are thin and flexible, you might be able to reach from above.)3. Remove the round cover with a quarter turn anti-clockwise.4. Remove the connector from the bulb5. The bulb flange is held by a wire clip. Push the clip to the front and then to the left.6. Grasp the bulb by the flange and remove.1. To replace, grasp the new bulb by the flange or connector.2. Clean the bulb glass with a new, clean cloth. Do not touch the glass or use a dirty bulb or you will get a lot more practice replacing bulbs!3. Insert new bulb, aligning the flange notch.4. Push the wire clip to the left, then front then to the right to hook into place.5. Press the power connector into the bulb.6. Replace the round cover.7. Replace the plastic covers from the hydraulics and the battery.Headlight bulb is H7. Combination Fog lamp/Main Beam is H4. Side light is W5W and snaps into place without a clip.