The easiest way to get to the top starter bolt is with 12" extension and a 13 mil socket. You have to feel your way between the solenoid and the block. You can only take the starter off from the top if the engine is on a engine stand
On the bottom rear of the engine near the transmission.
where is the starter located on a 1998 dodge grand caravan *Added* All starters will be located on the flywheel, transmission housing, Usually on the bottom side of the engine. Its a large cylinder with a smaller cylinder on it, akathe Starter and starter solenoid.
it on the right side bottom back of engine
the easiest way is to remove the oil filter and install the starter from the bottom of the car I removed the intake manifold to allow easier acces to the starter.
4 cylinder Look at the bottom of engine at the rear side of the radiator
4 cylinder should be at the front of engine behind radiator 6 cylinder should be at the rear passenger side at the bottom of engine
The starter is mounted to the bottom of the block next to the bell housing on the radiator side of the engine. It is in the same place on both the V6 and the 4 cylinder engines.
Answer - 4 Cylinder EngineThe starter is located under the intake manifold. You can get to it from under the vehicle.
6 cylinder? Lower rear end of engine4 cylinder ? front of engine behind radiator lower section Disconnect the - battery cableRaise and support vehicleRemove wiring harness at top of starterRemove mounting boltsRemove starter
If it is a 6-cylinder engine the starter is at the "front" of the engine about 10 inches behind the bottom of the radiator. You have to jack up the front of the car and remove it from underneath.
The starter is located at the front of the engine on the bottom half. It will be one large cylinder (gear) with a small one (solenoid) attached to it. You should be able to see it of you look under the front of the car at the front bottom of the engine.
Take the steering column housing off (usually held by 4 screws from the bottom) and remove the starter cap from the back of the ignition cylinder. In a Nissan, the ignition cylinder usually has a T shaped pin which turns the starter. if you can start your vehicle by turning the starter cap with a screw driver, you probably don't have an issue with the starter.