Want this question answered?
Power converters are used to change electrical energy from one form to another. It could be changing the voltage or frequency or it could be switching between AC and DC.
Power consumed by an electrical appliance will increase with a reduction of applied voltage.
A power supply does not create power or energy. This would be in violation of the Law of Conservation of Energy. Rather, a power supply changes the form of an available source of power or electrical energy into a form that is acceptable for use by electrical or electronic equipment. The input form is electrical energy defined by voltage or current or power, with a given impedance level, and frequency. The output form from the power supply is a different voltage or current or power, with a different impedance level, and possible a different frequency. Another possible is for the input and output to be of the same form but electrically isolated from each other for safety and performance concerns.
voltage
The r.m.s of sinusoidal power frequency voltage that the equipment can withstand during tests under specified conditions and for a specified time
It's double the frequency of the power source.
Power: energy transferred per unit time.In electrical circuits, in the simplest case power is voltage x current (in AC circuit, you also need to multiply by a so-called "power factor", which is often close to 1).Frequency: the number of cycles per second.Voltage: energy required per unit charge, when moving a charge between two points. Thus, the voltage is always expressed (or at least implied) as a VOLTAGE DIFFERENCE between two points.
The withstand voltage is the amount of electrical potential, measured in volts, which can safely be applied to an object in various environments, typically dry or damp or wet conditions, at normal atmospheric pressure and temperature. The object must still remain functional after the voltage test has been completed. This question refers to a test done in dry conditions. The question also mentions power and frequency, which are attributes which refer to the type of electrical service being used to perform the test. The electrical service may be either alternating current, running at a certain frequency, or direct current.
The electric voltage are energy to my system.
P states
An electrical circuit needs Voltage-electrical pressure pushing electrons, and Amprege-electron flow through a conductor. P=IxE (Power= Voltage x Amprege.
yes, it is possible to change the frequency in substations. frequency changer is a motor-generator set that changes power of an alternating current system from one frequency to one or more different frequencies, with or without a change in the number of phases, or in voltage. Sometimes a converter is used to accomplish this.