The firing order for the 6 cylinder engine Mazda MX-3 is 1 4 2 5 3 6.
1-3-4-2 distribitor rotation: counterclockwise
yes, you will have to remove all the plastics from the 94 and put them into the 92, as well as the wiring.
if its an interference engine you ill break valve and damage pistons if no it all good
bad ignitor or coil .
1-2-3-4 crankshaft is balanced during manufacturing and is intended to have 1 up in compression stroke while 2 is down after intake stroke, 3 is up after exhaust stroke, and 4 is down after power stroke, all at the same instant, as they rotate through the firing order.
You have to push the key & ignition switch in as you rotate it counterclockwise into the off position !!
In the fuse box under the hood, driver's side
What are the head bolt torque specs for a mazda mx3 1600
Right hand thread
The Mazda MX3 was first produced in 1991. It was introduced at the Geneva Motor Show in March of 1991. The MX3 was produced until 1998, when production was halted.
R12 -not sold in stores. can get filled or serviced at most auto repair shops.
A leaking gasket, a leaking filter, or a leaking drain plug....
On top of the fuse box, it's a sticker on the box cover
check the power steering fluid, and check the battery
check the power steering and check the battery
just beside the radiator under the front bumper, so on the driver side for a LHD car.
check power steering fluid and check to see if battery is good
* Auto recycler(junkyard) * Parts store(NAPA, Auto Zone, etc) * Possibly a Mazda dealer
This is done the same as the 1995 Mazda MX6. The answer is posted.
waste of time
well i just changed the brakes on my Mazda mx3 what you do is take the 2 pins out of the calipers which is holding the pads in place and then you are able to remove the pads
unplug all wires and fuel, vacuum and coolant hoses. undo 2 engine mounts and 2 transmission mounts. pull engine out. put new one in in reverse order
Between the throttle body and the Air box (air filter) Its the only metal piece on the hose between the two.