0
What is the first configuration change you should make when you first install a router?
Wiki User
∙ 13y ago
When you first install a router, before you do anything else, change your router password and disable the wireless network until you have time to set up and test the wireless security.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What is the first configuration change you should make when you first intall a router?
It is always good practice to change the default password to something else. If it is a wireless router you should also change the default SSID and enable an encryption method.
How hard is it if you want to change the configuration of an AP-G250 from router to access point?
To do this you should consult the manual, and your internet provider.
Which J-Web menu should you use to view the router's last known good configuration?
Configuration > Rescue
What is the procedure to find the router configuration page?
Typing in 192.168.1.1 into a web browser should open the router configuration page. From here, login data specified by the provider will need to be inputted in order to access the configuration page.
What should you do after running a command from the console on a perimeter router?
Update the configuration logs
What does it mean to configure?
a router is a device which need to be configured b4 online. Router configuration means What the router should do for us. it is a program containg the ip address the subnet mask the hostname ..
How do you change your Mac filtering?
You will need to access your wireless router's configuration. There should be a section for Wireless security, then there should be a section for MAC filter. Can't give specifics as you didn't mention the brand.
You want to verify the configuration register entry of a Cisco 2500 series router What command should you use on the router?
show version
You decide to buy a router to make this sharing possible Where on your network should you install the router?
Between the modem and the computers.
Where on your network should you install the router?
Between the cable modem and the workstations.
How do you get one router to use the signal of another?
You should use so called "Bridge" configuration.
What prompt should a technician see when entering the hostname command for a router?
from the global configuration mode
