0
What is the first task to be undertaken when setting and operating a center lathe?
The first task of operating a center lathe is to clean the area around it, the machine itself, and oiling the beds.
But if you are asking what the first task is when the preparation of the machine and workplace is done, drawing and material collected, chuck replaced if necessary, cutting tools selected and set up, then the first task on the machine itself would be to clamp the workpiece in the chuck.
What else can I help you with?
When setting up a network you should set up any computers running the Microsoft Windows 7 operating system in what order?
First
When was Windows XP Media Center Edition first released?
Windows XP Media Center is a version of the Microsoft XP operating system specifically design to operate as a home entertainment hub. The first edition of this software was released in July 2002.
How do you get heat out of defroster on 1996 beretta?
First you start the car. Then you let it idle or drive it until it reaches operating temp. Finally you turn the heater on to the defrost setting.
When was the first operating system created?
the first computer to use operating system was mark1
In which year the first operating ayatem was developed?
The first operating system was developed in the 1950s.
Which was the first operating system lounced by the Microsoft in 1981?
Microsoft 95 was the first operating system by Microsoft
What was the first major operating system?
D.O.S (Disk Operating System)
How do I find the status page on a KYOCERA FS-3920DN?
This page allows you to verify the machine's operating status. This will be the first screen that appears after COMMAND CENTER has been started up.
What was the first opperating system?
What operating system was coined the operating system of the century?
What is the first operating system name?
microsoft disk operating system
What is the first step in the process of setting margin?
the first step in the process of setting margins is getting a brain
Was Unix the first operating system?
No.
