answersLogoWhite

0


Best Answer

check the power source of all relevant devices

User Avatar

Wiki User

7y ago
This answer is:
User Avatar
User Avatar

danielle

Lvl 1
3y ago
correct

Add your answer:

Earn +20 pts
Q: What is the first thing to check for with any general connection problem?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

When you try to start my 89 caprice it just clicks what could be the problem?

Check your battery first, its terminal connection and connection leading to the starter.


What are the first things a person should check when there is no sound on the computer?

The sound card is the first item what you need to check. If have no problem with the card, you need to check the software. And maybe you need check the connection,


Can my DSL provider speed up my internet connection?

Contact your DSL provider if they are having maintenance works that affects your internet connection. If there are none, I suggest you contact them for visit on your place to analyze what is the problem. I suggest you should check first your pc if the problem came from your computer connections.


How do you reset the check engine light on a 2003 Isuzu Axiom?

You'll need a ODBII code reader to reset the check engine. The connection is under the stearing colonm. First check the code, clear the problem and the reset the light.


How do you fix a heater fan on a 1987 Toyota Camry?

First you have to determine what the problem is. The fan, fuse, switch, loose connection. Check the fuse first and then run power to the fan to see if it works.


When I turn the key on my 2003 Pontiac Sunfire there is a clicking sound.What could be the problem?

The very most common problem with all General Motors vehicles is the side post batteries. Corrosion builds up and you do not get a good connection. Remove the negative cable First and Install it last. Clean the battery terminal and the cable ends with a wire brush or a battery cleaning agent. Check the water in the battery. If this does not take care of the problem then you need to have a professional check it out for you.


What is the first step you would take when troubleshooting an external network such as an Internet connection issue?

define the problem


No power to fuel pump help?

check the fuse first then for broken connection


How can I tell if I have a faulty cable internet connection?

It depends on what is happening that makes you suspect your connection is bad. You might first get a technician on the phone to walk you through a check of the connections. Next, make an appointment for a service tech to come out and check the connections as well as the feed. Once you rule out any defects in the equipment or the service, you can move on to figure out what the problem is.


How can you tell if computer problem is the computer or internet access?

If you are having a problem connecting to the internet, there are several ways to tell if the problem is with your computer or your ISP (internet service provider). First, check your network connections from the control panel on your computer. If your computer says that you are disconnected, the problem is probably with the connection between your computer and your router. If not, the problem may be with your computer itself, your router, or ISP. Check your router's status indicator lights. If they are not blinking normally the problem is most likely with your ISP or the router itself. If not, it is probably a problem with your computer. Answer Check out in this order: System, Program, User...


How do you get internet on an itouch?

First click on the general icon it should have gears on it the en go to wireless connection


2003 Mercury Grand Marquis radio is dead how do i repair?

First, check the fuse to make sure that it has not been blown. If the fuse is okay, i would check to make sure that there is power at the fuse. If there is its time to take the radio out and check the connection behind the radio. If the connection is snug in the radio I would check the voltage on both power inputs to make sure that they are each getting 12v of power. If they are then your radio may be toast. If not you need to look at the wires a little closer to find the problem. It may be a bad wire or bad connection somewhere along the lines.