answersLogoWhite

0

What is the forces of a fan?

Updated: 8/17/2019
User Avatar

Wiki User

βˆ™ 14y ago

Best Answer

Thrust, measured by how much cubic feet of air moved in a room.

User Avatar

Wiki User

βˆ™ 14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the forces of a fan?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Is yusei in the new Yu-Gi-Oh exiled forces?

no yusei is ONLY in yugioh 5ds This Exiled Forces seems to be something fan-made; like Dragonball AF.


When a room is hot is it better to have the ceiling fan turn clockwise or counter clockwise?

When a room is hot it is better to have the ceiling fan turned counter clockwise. This forces the air to blow down. In the winter the fan should turn clockwise to keep the warm air higher.


When the fan blows cooler air from outside the car into the car and forces warmer air in the car out is this an example of conduction convection or radiation?

convection


Is forced draft has negative pressure drop?

No, the forced draft fan has positive pressure as it just forces yhe air into the combustion chamber.only the induced draft fan has negative pressureas it removes the flue gases & exhaust gases is stacked up


What is the purpose of the thermostatic switch in a cycling clutch system?

A thermostatic clutch is usually used on a car's engine cooling fan. It uses a bi-metallic spring, which tightens and forces the fan to turn when the air temperature inside the engine compartment reaches a certain level. Basically is used to prevent the fan from wasting your engine's power when there is no need for cooling, by allowing the fan to freewheel when the engine is cold. It then serves as a device to automatically engage the fan and keep the engine cool when necessary.


Why does air rush into a vacuum cleaner nozzle?

To understand why air rushes into a vacuum cleaner nozzle we need to trace air flow in the machine. Let's do that. The motor in a vacuum cleaner spins a fan, and the fan moves air. The air intake for the fan is connected to ducting that is routed to the nozzle. As the fan forces air out in its exhaust stream, it creates low pressure on the suction side of the fan. This low pressure (a partial vacuum) is felt along the air path to the nozzle. At the nozzle, outside air pressure forces air into the ducting where air pressure is lower. The moving air has picked up debris and carries it along. That debris ends up in a bag or filtered dirt canister or someplace else where it can accumulate and be collected for disposal. This applies to machines that have bags or filters to get the debris out of the air stream before it goes through the motor to keep it cool. Some machines isolate the motor from the air stream created by the fan, and the motor is cooled by another fan. These "direct" vacuums operate in a way that sees the air stream and the debris pass through the fan and be driven into a bag. The operation of the fan has created a low pressure area along the ducting between it (the fan) and the nozzle. Outside air pressure, being greater than the low pressure created by the fan and ducted to the nozzle, forces air into the nozzle.


What causes a 1998 Ford Escort to overheat?

"Your two most obvious answers would be either a bad thermostat, or a bad water pump." These are two possible problems. Does the car only over heat when idling in traffic for instance? If so does turning on the A/C make it cool down? If this the case you may have a bad fan switch which is actually more likely. A bad fan switch will not turn on the electric cooling fan when it should. Turning on the A/C forces the fan to come on regardless of what input the fan switch is giving.


Why would the fan only work after air has been forced through it while driving?

sounds like the motor is bad. Loosing too much power, needs assistance from kinetic forces.


What was the most common type of force being used?

There are nine types of forces you can apply to simulations and they include; drag, gravity,attractor, eddy (vacuum),fan,toric, turbulence, vortex and wind.


What is Fan-in and Fan-out with reference to program structure?

fan in fan out


What forces are pull forces?

Forces such as tension , gravitation are pulling forces.


Social environmental forces?

Economic forces, Technological forces, Political-legal forces, Sociocultural forces.