answersLogoWhite

0

the suction valve is transfered fluid one pipe to another pipe at a specific pressure and quantity.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

Why does inlet valve opens before the beginning of suction stroke?

for completely entering of fresh charge the inlet valve opens before suction stroke


Where is the suction recharge valve 2000 Ford Focus?

where is the suction recharge value on a 200 ford focus


Where is the freon low side on 2006 dodge 1500 truck?

The low side is from the H-valve or orifice tube to the suction side of the compressor.The low side is from the H-valve or orifice tube to the suction side of the compressor.


What is the function of suction valve in refrigeration system?

Once the fluid travels through the radiator on the back of the refrigerator, the valve will open and use the force of the piston retracting to suck the fluid into the compressor, where the pressure will cool the refrigerant over again.


Where must a suction - line drier be placed in a heat pump after a motor burnout?

Between compressor suction and reversing valve,also called true suction.


Where must a suction line drier be placed in a heat pump after a motor burnout?

Between compressor suction and reversing valve,also called true suction.


In what position is a suction service valve when operating?

middle position


How Air suction valve work in Bike?

Air suction valve connected between air filter and exaust manifold.it converts carbon monoxide to carbon dioxide. sanjivkumar p kmnr kfi


What are symptoms of a bad PCV valve?

valve should rattle when shook, and when engine is started it should have a good suction.


What the function of motor operated valve actuator?

The main function of a valve actuator is to control the valves ON to Close or modulating the valve,and the motor operated valve actuator is one important kind of valve actuator,the main different between kind valve actuators is it drive by electric power.


Your ingound pool has to much suction you cannot move the brush on the bottom of the pool even with the valve almost fully open?

You can get a by pass valve that will alleviate some of the suction by taking water into the hose at another point.


How To add refrigerant to the system through the suction service valvethebvalve stem must be?

To add refrigerant through the suction service valve, first ensure that the system is off and properly evacuated. Then, remove the valve cap and attach the refrigerant hose to the suction service valve. The valve stem must be depressed gently to allow refrigerant to flow into the system. Monitor the pressure and adjust accordingly, ensuring not to overfill the system.