for boiling the water to produce the steam... this steam helps to rotate the turbine...
that's the water that get's heated thicko
One function: to safely heat water. Whatever the resulting hot water or steam is used for is not a function of the boiler, but the system it is connected to.
steam boiler
there are two water level indicators usually mounted in front of boiler to ascertain the level of water inside the boiler am explain construction and working on next page
there are two water level indicators usually mounted in front of boiler to ascertain the level of water inside the boiler am explain construction and working on next page
it is used to burn the fuel(coal,usually) with primary and secondary air.the burning coal is then used to heat the water in the boiler to produce steam.
deaerator is a device used to remove dissolved oxygen and carbondi oxide in boiler feed water. it causes scaling inside the boiler tubes and economizer also.
This is where water is turned into steam at high pressure, which is then fed into the steam turbine
NONE a boiler is a boiler and a water heater is a water heaterSEE ASME section IV or the NBBI
Boiler feed pumps are an important part of any boiler operation. They control the amount of water fed to the boiler and the manner in which it is fed.
A fish boiler is a hous boiler that stores fish instead of water.
a boiler operator should know and be capable to run it smoothlyt
Function - It adds the pressure to the feed water before it entyers into boiler feed pump suction Advantage - Ensures high margin NPSH A for boiler feed pump spinning at high rpm (5250Rpm) Drive for booster - Normally @1450 rpm Type of impeller- Mostly preferred Double suction