It has no governor. Speed is computer controlled. That speed is way more than you will ever need to drive this vehicle.
Right around 107 MPH (Remember that your speedometer will read different)
The Powertrain Control Module will cut back on the fuel to protect the engine
What causes back firing on a ford explorer and it to idle rough and want to cut out when you try to give it gas.
AnswerTry to buy ford speaker adapter plugs so you don't need to cut wires and mess the electric system up. You can get them from Ebay or Amazon
On a 2003 Ford Explorer : The fuel pump shut off switch ( inertia switch ) is located in the front passenger footwell , by the kick panel
The 1998 Ford Explorer Owner Guide shows that the fuel pump shut off switch is behind the kick panel in the front passenger footwell
On a 2002 Ford Explorer : Yes , if you mean the fuel pump shut off switch ( inertia switch ) It's located in the front passenger footwell , by the kick panel
In a 1997 Ford Explorer : The fuel pump shut off switch ( inertia switch ) is in the front passenger footwell , by ( or behind ) the kick panel
The 1997 Ford Explorer has a wide open throttle A/C relay in the power distribution box in the engine compartment , so if you " floor it " apparently YES
no . unscrew and screw back on
The 2005 Ford Explorer OBD 2 port is on lower edge of dash; left of steering column directly above parking brake release handle in panel cut out.
Explorer has an emergency shut off switch for the electric fuel pump which may cut the fuel supply.It is triggered in a collision. The switch is located at the foot of the front passenger seat. Explorer has an emergency shut off switch for the electric fuel pump which may cut the fuel supply.It is triggered in a collision. The switch is located at the foot of the front passenger seat.